Z Axis Pre-setter Tool Setter 50±0.005mm Magnetic Determinator Table Set for

Specification:
: Silver
Material: Die steel
Reading: 0-50-0
Accuracy: +/- 0.005mm
Setting height :50 +/- 0.005mm.
Size: Setter: 6.2cm x 5cm/2.4'' x 2''
Case: 9.3cm x 9.3cm x 8.4cm/3.7'' x 3.7'' x 3.3''
Checking bar: 6.1cm x 0.7cm/2.4'' x 0.3''

Package Include:
1 x Z Axis 50±0.005mm Setter with Table
1 x Checking bar
1 x Case

Feature:
For setting length on machine center/lathe center.
Z-axis tool setting is used to set the length of the machine tool.
Large measuring surface and easy to operate.
Low sprang force, avoids the milling or the drilling bits broken.
Easy to be calibrated by a ground parallel or block.
Better parallelism , sensitivity and precision for use.
Botton has magnetism.

Using methods:
1. surface below the fine-tuning, adjust the height measurement by parallel blocks;
2. is a high precision instrument is not suitable for this set of Vernier measuring accuracy;
3. rapid feed room lights slightly back until the light is off, then slowly advances to the light to determine accuracy of master;
4. side when the probe, to highest point on contact probe.

Notice:
1.Please allow 1-3cm error due tomanualmeasurement.Pls make sure you do not mind before you bid.
2.The may have different as the difference display,pls understand.











a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a