New Waterproof Underground Electric Dog Fence Fencing System 1 Shock Collar Kit EU Plug Eurocode

Introduction:
This hidden fencing system is among the most reliable, cost-efficient pet containment systems available today. A buried wire transmits a harmless radio signal. When you dog approach the boundary, the signal causes the dog’s collar receiver to deliver a warning beep first. If your dog continues closer to the boundary, the system will issue a mild stimulate. If your dog continues further, the system will issue stronger stimulate until your dog returns to within the boundary your have set up. Your dog will naturally seek to avoid correction, and is content staying within established boundaries.

Features:
1. For all dogs with update version ,and most reliable.
2. Pulsed Proportional Stimulus - The closer your pet gets to the boundary, the more intense
3. Progressive Tone Stimulus - A warning tone will be issued first, then a stimulus if your dog continues to move closer to the boundary.
4. Boost Switch- Allows the width of the warning are to be adjusted
5. Speed Detect Anti-Run Through(Effective distance:5M)- The faster your dog is moving, the quicker the higher level of intensity is issued
6. Audible Wire Alarm- The system's control center has an audible alarm to alert you if it senses a in the wire or if the boundary system is not functioning correctly
7.Visual Wire Alarm- The system's control center will light alsoup if it senses a in the wire
8. Quick Disconnet Terminals- quick and secure connection or disconnection of the wire to the control center
9. Low Indicator- When the light on the collar is green, it is working properly. Red means time to replace the .
10.The update version ,New waterproof funtion,most reliable.
11.Up to 5000 square meters range. Over 1.2acre.
12. Collar . Circumference: 58cm .

How to setup:
1)Wall-mounted transmitter: Transmitter is the central controller to whole electronic system. Make sure the wire is set to a loop.
2) The receiver collar: Receiver (collar) will make a warning beep firstly and then continuous stimulation if your dog attempts to approach wire boundary.
3)How to install the system:
a. Design your containment area and calculate the amount of wire needed.
b. Install the wall transmitter.
. Lay out the perimeter wire.
d. Connect the perimeter wire to the wall transmitter.
e. Verify transmitter is functioning without problem.
f. Set up the receiver and then, the containment system and adjust the field width.
g. Install the boundary wire and training flags.
h. Fit collars to your dogs and train your dogsi. Then you can enjoy with the trained dog

Note:
Please read the manual carefully before using.

Package included:
1x Indoor Wall mounted transmitter
1x plug
1x Adjustable receiver collars
1x 9 volt for collar
1x Boundary wire of 300 meters
2x Extra metal contact points
20x Training flags
1x blub
2x Screws
1x User’s manual

























a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a