Supports , P-25, D-Star and system
Fully tested
Onboard LED to show status (TX,,PTT,Mode)
SMA antenna connector, antenna included
Clean mounts on all raspberry current pi including pi zero with /2w Mode: support both duplex mode and single mode
Differences in duplex and simple: in duplex mode, it has 2 time slots, and tx and can do at the same time
Radio Frequency: in duplex mode, support uhf 430-440mhz, in single mode support uhf 430-440mhz and vhf 140-150mhz
Best fit: tx = 0, = 0, no needed.
Modem select: STM32-DVM/MMDVM_HS- hat (gpio)
Antenna: onboard two antennas
: Onboard to show status, with status words on How to write wifi details to hotspot: 1: generate wifi configuration file and connect it to tf card.
We need a TF reader. Put TF card into this TF reader and plug that into computer.
Go to http://.pistar.uk/wifi_builder.phpand then fill in your wifi name in ssid, password in , click submit. Then the wwpa_supplicant.conf file. is generated. Drag this file to the path of your tf card. And plug the card into your hotspot. Turn on your hotspot and wait 1-2minutes.then let's go tohttp://pi-starand play with the . keep this in mind that gadget only supports 2.4Gigahertz router, and does not work with 5.8G router.
Model Number: MMDVM Hotspot Board
Type: module
Type: Voltage Regulator
Type: For MMDVM color:White
Material:PCB Package Contents:
1 x MMDVM Hotspot Board Only the above package content, other are not included.
Note: Light reflection and different displays may cause the color of the item in the a little different from the real . The measurement allowed error is +/- 1-3cm.