【Compatible cameras】
- Olympus OM-D E-M1, E-M5, E-M5 Mark?II, E-M10, E-M10 Mark?II
- Olympus E-P1 E-P2 E-P3 E-P5 E-PL2 E-PL3 E-PL6 E-PL7 E-PL8
- Olympus E30 E400 E410 E420 E450 E510 E520 E600 E620
- Olympus SP-510 UZ, 550 UZ, 560 UZ, 565 UZ, 570 UZ, 590 UZ
- Olympus STYLUS 1, 1s, SH-1, SH-2
- Olympus XZ-1, PEN F
* JM-J(II) replacing Olympus RM-UC1
【Please NOTE】
* The picture are the same for different suitable brand, please according to the description not picture to select your suitable remote, because the picture may not correct, but the description for cameras are correct.
【Package includes】
- 1x Transmitter
- 1x Receiver
- 1x Cable
- 1x Manual instruction
- 1x CR-2 battery
- 1x 23A battery
【Product Highlights】
- 16 possible radio channels, Operate on Radio Frequency 433 MHz
- 1 transmitter can trigger multiple receivers
- Up to 30 meters / 100ft range
- Can trigger cameras wireless or wired
- Can wirelessly trigger the camera shutter under 5 modes: single shot, unlimited continuous shots, bulb shot, 3 continuous shots and 5 seconds delay shot
- Receiver itself acts as a cable switch
【How to use】
1. Install the CR-2 battery to the receiver and 23A battery to the transmitter. (Make sure to remove the plastic protective paper on the battery before installation)
2. Set the receiver and transmitter to the same channel (Normally the channel is already matched when you receive the package, so actually you don't need to set it, but it you ever reset the channel, make sure they are the same)
3. Once the batteries are properly installed and the channels are matched, when you press the shutter on on the transmitter, both the LED bulb on the transmitter and receiver will light up.(If not, please check if the battery is installed correctly or the battery is dead)
4. Once the transmitter matches the receiver, connect the receiver to the camera via the camera connecting cable which is included in the package,then set the transmitter into the working mode you want and finally press the shutter on to take a photo wirelessly.