GRBl USB 4 Axis Motor Driver Control Board For DIY Laser

Package included:
1 X USB 4 Axis Motor Driver Board
1 X USB Cable
1 X 2Pin DuPont Lines
1 X 3Pin DuPont Lines
5 X 4Pin DuPont Lines

4 Axis Motor Driver Board Controller Laser board For DIY Laser

Specification:
1. Interface:USB
2. Size:100mm*80mm
3. Requirement: higher than12V 2A
4. Motor:Motor within 2A 2-phase 4-wire
5. Input Voltage: 7.5V-12V (the voltage will affect the laser effect))
6. Interface: 5.5 - 2.1 (Inside is positive electrodes and ouside is negative electrodes)

Feature:
1. Expansion of functions: Limit, subdivision, stop, hand control, the fan, low light, external relay
2. Fit for DIY desktop laser ,dispensing machines printer,plotter,tool .
3. 4-axis linkage, Y-axis dual interface, can drive a motor within 2A 2-phase 4-wire
4. USB interfaces, 12V supply, delivery lines! Send software! Technical !
5. Large MOS tube,onboard buck module, wire jump ADJ can adjust manually the laser voltage to control the laser

Note:
1. inserted in ADJ, Regulate the voltage module can control the laser voltage
2. 5V laser module group should wire into ADJ and regulate the output voltage of 5V or less to pick Laser Module
3. The motor can not work hight than 2A, when the motor work for a long time in 1A to 2A , please pay attention to heat








a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a