Universal auto start stop entry system engine start alarm system push one-on start system e car accessories

9Pcs 12V Car SUV Push on Start Keyle Entry Engine Start Alarm System Push on e Starter Stop Auto car alarm system

s:Product Name: Car Push on Start SystemProduct Alias: keyle entry, e start, one key start, keyle start, e start, smart start, comfortable entry, one key ignitionApplication: for 12V general purpose products like storage battery cars, , pickup truck, SUV, etc.Operating Voltage: 12V ± 3VStatic Current: le than 10mAWorking frequency: 433 MHzFeatures:Car ligent push on start system comes with the smart chip and a key to start and flameout the car, g convenient and simple to use.PKE keyle entry & automatic r switch lofunction. The automatic r will unlothe car when you are 2 m/78.74 inch near the car.With the e start / flameout, ten minutes countdown function.The car is cool in summer, but warm in winter. No longer endure the uncomfortable car environment.With the ID identification function. The e controller can't work normally when it comes to the ID identification.Key operation:Do not step on the brake, pre the on to turn on the ACC sound, then pre the ''on'' on on the dasard to e the indicator light f. And then pre the on to cycle the operation.Brakes the car, short pre the on, the system ignition starts, and light is always on.When the flame is turned on, the brakes are short preed and the system is turned off.Step on or not step on the brakes, pre and hold, the system can let go after the ignition with the light always on.

Q&A :1.How to find the ACC wire?Please rearrange the 6P cable, after you twist the key to the first gear position (you can listen to music at this time), measure the line that has electricity on your car is the ACC line.2. For your 6p cable, but my car is only 5p. what can i do ?If your car is a 5P line, the right connection is normally 1 power line, 1 ACC line, 2 ON lines, and 1 start line. If you didn't follow this step, it means you got wrong installation. pls recheit again. and pls remember 2 ON lines need to distinguish which is ON1 line and which is ON2 line. If the two ON lines are always charged at the time of startup, you need to connect the two ON lines in parallel.3. How to tell the wire ON1 and ON2?If you test these two ON lines at startup, one of the two that always has power is the ON1 line. And If the other one has instant power is the ON2 wire.

Packing list:1 x Host2 x e Control Handle1 x Start on2 x Sensing 1 x Start Harne1 x Harne1 x Restore on1 x Manual