Universal 5D Shark Fin Auto Car Radio s FM AM Stronger Signal Piano For Peugeot 2008 207 SW RC 301 3008

5D Shark fin

By DA

Features and specifications:

5D shark fin made from ABS plastic. It is coated in piano and comes in 14 colors. Features a 3M adhesive for a strong hold.

Note:The shark bottom hole measures 12.3 x 5.7 cm. Please e sure your base is smaller than that to ensure fit. If your base is larger, please order the super shark as it can fit a larger base.

Colors

Showcase

Dimension

Shark fin: length 21.3 cm (8.4 inch), width: 8.2 cm (3.2 inch), height: 6.8 cm (2.7 inch)Bottom hole: length: 12.3 cm (4.8 inch), width: 5.7 cm (2.2 inch)

PET-L  cable for a stronger signal.

Piano /Plating/Carbon, ABS plastic

Bright surface, non-fading, ble ABS plastic

Package include

1 Shark fin 1 PET-L  cable1 3M adhesive1 pair copper screw and nut

Easy to install

① Stick the 3M adhesive onto the bottom of the shark fin.② Remove the .③ Tighten screw and nut on the base.④ Carefully align the shark fin and pre down for 2 minutes to aure adhesion.

FAQ:Question 1:The shark same color with the car color?Answer 1:The shark fin color very close the color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impoible exactly the same as color,hope you understand that.Question 2:How about the radio signal effect after installation?Answer 2:This using purification copper fittings,through our tested,the signal close .Question 3:The shark installed on the roof have little gap, is appropriate?Answer 3:The shark bottom is little curve,most of models no have gap,few car  may be have a little gap,it does not affect the use.You can use more adhesive in to the gap.Question 4:What should be note when installing?Answer 4:Clean around base,be sure without water or dust,first connect the cable and base,test the radio,if it is ok,than installing,heating 3M adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the positionpreing 3 minutes after pasted,keep dry in 2 days.