This website uses cookies
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
In stock
Shipped from abroad
Free return within 15 days for all eligible items.Details
Yankkios
84%Seller Score
36 Followers
Shipping speed: Average
Quality Score: Excellent
Customer Rating: Excellent
5D Shark fin
By DA
Features and specifications:
5D shark fin made from ABS plastic. It is coated in piano paint and comes in 14 colors. Features a 3M adhesive for a strong hold.
Note: The shark bottom hole measures 12.3 x 5.7 cm. Please make sure your base is smaller than that to ensure fit. If your base is larger, please order the super shark as it can fit a larger base.
Colors
Showcase
Dimension
Shark fin: length 21.3 cm (8.4 inch), width: 8.2 cm (3.2inch), height: 6.8cm (2.7inch) Bottom hole: length: 12.3cm (4.8 inch), width: 5.7 cm (2.2 inch)
PET-L cable for a stronger signal.
Piano paint/Plating/Carbon, ABS plastic
Bright surface, non-fading, durable ABS plastic
Package include
1 Shark fin 1 PET-L cable 1 3M adhesive 1 pair copper screw and nut
Easy to install
① Stick the 3M adhesive onto the bottom of the shark fin. ② Remove the . ③ Tighten screw and nut on the base. ④ Carefully align the shark fin and pre down for 2 minutes to aure adhesion.
FAQ: Question 1 :The shark same color with the car color? Answer 1 :The shark fin color very close the color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impoible exactly the same as color,hope you understand that. Question 2 :How about the radio signal effect after installation? Answer 2 :This using purification copper fittings,through our tested,the signal close . Question 3 :The shark installed on the roof have little gap, is appropriate? Answer 3 :The shark bottom is little curve,most ofmodels no have gap,few car may be have a little gap,it does not affect the use.You can use more adhesive in to the gap. Question 4 :What should be note when installing? Answer 4 :Clean around base,be sure without water or dust,first connect the cable and base,test the radio,if it is ok,than installing,heating 3M adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the positionpreing 3 minutes after pasted,keep dry in 2 days. About shpingThis product has no ratings yet.
Subscribe to our newsletter
and be the first one to know about our amazing deals!