TIDEWAY 15mm Angle Drill Bits Hole Woodworking Tools Wooden Hole Puncher-15mm

Specification:
Brand: Tideway聽
Product grade:聽Industrial grade
Material:聽Tungsten steel
Type: End mills
DIY Sulies:Woodworking
Alication: Bench trimming hine, carving hine.
Size Diameter聽 Total length聽 肖12 12mm 85mm 肖15 15mm 85mm 肖17 17mm 85mm
Features:
1. Specially prepared for bench trimming hine, portable hine and so on.
2. No polishing, smooth , no burrs, no burrs, no blaening.
3. Wide range of alications, such as factory building materials, home shops, carpentry enthusiasts.
4. The is made of high quality hard alloy and carefully designed, developed and ed repeatedly, which not improves the service efficiency,聽
聽 聽 but also significantly improves the durability and noise reduction.
5. The hilt is made of hard 45 steel. The ral design is wear-resistant and not .聽
6. New spray coating, wave resistance to high temperature, corrosion and features, extended service life.

Operation precautions:
(1) The woodworking milling is specially designed for the portable and desktop woodworking hine, and cannot be used in the hine like electric drill, drilling hine and so on.
(2) tools can produce smooth suace for wood such as hardwood, softwood and synthetic board, but should avoid processing metal materials such as coer and n as well as non-wood materials such as sand and .
(3) e sure to use the clamping sleeve of aropriate size, because it is worn seriously, not round enough and with taper of inner bore cannot provide enough clamping strength, which leads to ion or fly off when the handle is broken.
(4) Never ume that the new jaet is safe and reliable.When uneven contact marks or grooves are found in the handle part after clamping, sl situation and inner hole deformation of the clamp should be replaced immediately to avoid accidents.
(5) When the is installed and clamped, stop the hine immediately if it is found that the k has a fluttering phenomenon when working. Repeat the clamping for several times so that the tool handle and the clamping sleeve are in full contact and the work is carried out.
(6) The tool handle should be in good contact with the clamping sleeve, and the tool handle must be fully inserted into the clamping sleeve and tightened firmly, so as to provide sufficient clamping force for the tool.A small part should not be inserted into the sleeve, wise it may cause breakage of the shank and damage to the .
(7) Aropriate research and ear protection devices should be used during operation. Paage Included:
1 X Hole 聽

More Details:聽
聽
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a