Road Stud LED Parking Road Reflector Rear Warning Lamps Aluminum LED Flashing Spike outdoor waterproof

Warning light
Description: Solar road stud is one kind of road studs, Its set up along the sides of the road to Indicate the direction, At night time or during the rainy or fog weather. It made of reflection material, shell, solar panel, led light and control components . As for its active light-emitting and light reflection ability it usually used in conjunction with the road marking sketching the outline of the road, to improve road safety.
Specifications:
Solar panel: Mono-crystalline 2V/150mA
Storage devices: 1.2V/600MAH high temperature Ni MH battery、
Working hours: can work 40 hours when charge a day under standard intensity, more than 72 hours of continuous work after charge full battery.
Display mode: always bright
Display color: white
Display devices: 6pcsΦ5 super bright LED.
Viewing distance: >800meters
Light intensity: 400-500Lux
Working life:nickel metal hydride battery 3-5 years
Working environment: -20℃~ +70℃
Material: die casting aluminum shell + reflector film + imported PC material roof, anti UV, anti yellowing
Waterproof and static compressive capacity: IP68, static pressure is greater than 20 tons
Package Included:
1*warning Lamp
installation 1. In terms of installation tools
The tools required for installing solar powered road studs include: electric hammer, ruler, screwdriver, small rubber bucket, chalk, generator, electric hand drill, and glue mixer.
2. Auxiliary materials
Epoxy resin A, B, cement
3. Detailed installation steps for solar powered road studs:
(1) Firstly, it is necessary to use a ruler to determine the installation position of the road spike, and install one at 15m (or directly according to the installation distance required in the drawing), ensuring that the position of the road spike is in a straight line in the longitudinal direction and also aligned horizontally to the left and right.
(2) The ratio of adhesive for installing road studs is 1:0.7 for A adhesive and B adhesive, and then 15% -30% cement can be added to increase the strength of the adhesive after solidification. (Note: The adhesive should not be stirred too much at once. It is sufficient for one person to stick 50-70 road studs, and each nail requires approximately 40-50 grams of adhesive.)
(3) Before installing the road spike, it is necessary to clean the road surface at the installation location. After cleaning, use a screwdriver to apply approximately 40-50 grams of adhesive on the back of the spike and place it in the designated position. After placing it, press and rotate it twice to make the spike and road surface bond tightly.
(4) After the installation of the road studs, it is necessary to use a screwdriver to scrape off the adhesive that has spilled around the studs and clean the road surface.
(5) Two hours after the installation is completed, it is necessary to conduct a further inspection of the installation situation and check for any leakage or installation deviation. If there are any, they should be dealt with in