QIACHIP 433 MHz AC 110V 220V 2CH RF e Control Switch Controller + Universal RF Relay Receiver For Light Garage Door Opener

Features:

*Support Multe Working Mode: Momentary, Tole and Latching Mode.
*Support the type of e controlSupport Code: Learning Code1527, Fixed Code2262.
*Support storing the quantity of e control: 25 PcsNOTE: The system can only store 25 pcs of e controls, if the e get more than 25 pcs, the initial e control will be lost.
*RF Working Mode: rheterodyne ReceptionModulation Mode: ASK.
*Perfect suitable for e control of roller shutter door, garage door, electrically operated gate and other telecommand equipments.
Working environment: -15*75 degrees Celsius

Technical Data Of Receiver:

Model Number:KR2202-4
Input voltage: 220V
Working current: 10A
Maximum load power: 1100W x 2
Frequency: 433Mhz
Support en format: EV1527
Wiring method: NC COM NO
Working mode: Momentary, Tole, Latching Time delay

About Working mode:

Momentary: Press the e on, the relay connects, release the e on, the relay disconnects.
Tole: Press once the e on, the relay connects, press the e on twice, the relay disconnects.
Latching: Press the e on A, the relay connects, press the e on B, the relay disconnect.

Learning the Code:Momentary

Press the learning key on the receiver once time, it comes into momentary setting mode.
Wait for a moment, the LED will be off , it comes into learning state.
Push the e on, LED indicator on the receiver board will f then come off.
After 3 seconds, the LED indicator will be on again, learning successfully.

Learning the Code: Tole

Press the learning key on the receiver twice time, it comes into tole setting mode.
Wait for a moment, the LED will be off , it comes into learning state.
Press the e on, LED indicator on the receiver board will f then come off.
After 3 seconds, the LED indicator will be on again, learning successfully.

Learning the Code: Latching

Note: When you choose for latching mode, in order to learn more e control, you need to learn two different on, the first time learning is for ON, the second time learning for OFF.
For example: on A = ON, on B = OFF
Press the learning key on the receiver tre time, it comes into latching mode .
Wait for a moment, the LED indicator on the receiver board will f then come off.
Press the e on A. LED f for 5 times.
Press the e on B. LED f for 5 times
After 3 seconds, the LED indicator will be on again, learning successfully.
A = ON, B = OFF.