This website uses cookies
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
In stock
Shipped from abroad
Free return within 15 days for all eligible items.Details
JessiBanks
60%Seller Score
Be the first to follow
This seller does not have enough history for us to evaluate his performance yet
Description:
Photographic film, also known as dry film, is used to make PCB board, stick it on top of the PCB, it will become a sensitive circuit board.
The dry film is resistant to most of the acid etching solution, the PH value can be resistant to most alkaline etching solution between PH8.0-8.5.
1.5 mil dry film can fully cover a 0.25 inches thickness hole.
The dry film is available in most common use of the plating bath, no wrinkles, no color.
Length: 1m
Package Includes:
1 Piece Photosensitive Dry Film
Note:
Operating steps:
1.grinding CCL, this simple, using the finest polished clean water frosted paper on the line.
2.removing film, photographic film is sandwiched between two layers of film, the first side can make use of transparent tape tear torn, try a few on the line.
3, and then foil, copper clad laminates can look a little cleaner, pasted, try not to have bubbles.
4, good paste membrane used presses, not too hot, about 100 degrees from the fixing.
5, the printed circuit board film, suggestion is to use film, the fine could reach the highest degree of accuracy if you did not ask for the paper to print it with sulfuric acid trip.
6, the printed circuit on the photographic (Note: Dry film is negative, so to highlight the print, which we usually use photographic opposite) with energy-saving lamps 10 or so, if there is exposure Machine 1 minutes on the line, the sun not tried, it should be - , the exposure process Obviously, since the photosensitive film will change color when exposed to light, the light becomes dark blue. You will easily see your circuit diagram appeared on the board.
7, developing and tear the on the front panel, into the developer (developer according 1:100,10 gram Total 1L of water) to be used when developing a little harder stick cotton wipe board.
8, etching, this goes without saying (ferric etchant environmental For protection, hydrochloric acid + , etc.) is recommended environmental etching shop, fast, clean, no odor.
9, after a good CCL etching, stripping, from film watered by 1:60 or 70, the board bubble like a few minutes,
10, after the completion of the board, very pretty good, most dense line spacing is 0.1MM, width 0.1MM, 0.1MM lines do know though is very easy to do, but do 0.1 lines and 0.1 line spacing dry film can easily do it.
1 Piece Photosensitive Dry Film
This product has no ratings yet.