MK S Gen V1.4 Control 3D Printer Mainboard Compatible RepRap Ramps1.4

Feature:

1. It gather 2560 and ramps1.4 on a same board, which solved the Ramps1.4 combination interface problem that easily out of order. 2. Can replace the motor driver, 4988 drivers and 8825 drivers 3. Circuit board uses the high quality of 4 layer board,optimize heat dissipation;Ramp Is 2 layer board 4. Using special supply , the 12v-24v input, solve the problem of Ramps voltage conversion of fever. 5. Accept 24V input, under the same system can reduce the current hot bed to 1/4, effectively solve the problem of hot bed MOS tube heating 6. The can use open source Marlin, configuration are exactly the same with ramps1.4 , can be directly replace ramps1.4 also Can be connected directly to Ramps1.4, 2004 LCD control board and the LCD board (12864) 7. Provide three 5V output, three 12V-24V output interface.

4988 Driver Connection:



plug is High, remove to Low.



Diagram:





Note:

If the supply is wrong connection, motor driver board is likely to be burned and circuit, please confirm again after repeatedly for electricity.

Package included:

1 x MGK Gen V1.1 Motherboard
1 x USB cable ,,,,,,,,,










a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a