This website uses cookies
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
2 units left
Shipped from abroad
Free return within 15 days for all eligible items.Details
BX Department Store
88%Seller Score
1 Followers
Shipping speed: Excellent
Quality Score: Excellent
Customer Rating: Average
This is a manual sewing machine, but it's superb, enough for your daily sewing!You can refer to the instructions in the color box to use.
The correct way to use the miniature sewing machine:
1. Holding the machine: Hold the machine base with the four fingers of your right hand, and place your thumb naturally on the top of the top cover of the machine body to hold the whole machine smoothly.
2. Threading:Pull out the thread on the bobbin gently. Pass through the lead wire figure A, and then introduce the clamping line adjustment piece
B. And then through the lead wire loop. C. Lead through the thread temporarily placed next to the needle, another threader from the front of the needle (to the body of the combination of) through the needle hole, and then introduce the thread into the threader small holes, exit the threader to pull out the head of the line about 2-3 centimeters pressure plate pressure can be used!
3. Put the fabric: with the right hand index finger lift up the pressure plate, will be ready to sew the fabric (thickness of not more than 0.8 mm) flat into the pressure plate under the pressure, gently put back to the pressure plate to press the fabric;
4. Sewing operation: hold the fabric with the left hand, the right thumb gently and quickly press down the top of the upper cover to the bottom, then press down again with the thumb, and so on and so forth, the fabric feeding mechanism automatically sends the sewn object to the left. The right hand gradually moves to the right, and the left hand holds the fabric and gently moves the sewed object to the left in accordance with the sewing rhythm until the end of sewing;
5. Finish: When sewing is finished, cut the thread with scissors and gently pull up the presser to remove the fabric. From the opposite side of the sewn fabric, pull out the thread, make it wear into the next section of the coil to pull tight and tie a knot, the stitches will be firm, sewing end do not pull the fabric in a hard way to pull off the thread, in order to avoid pulling the bad needle, pins and needles;
6. The machine can automatically feed the fabric and adjust the tightness between the pins, but it is necessary to pay attention to the following points:
A. The pin is too tight, the pressure nut slightly counterclockwise;
B. Pin too loose, the pressure nut slightly clockwise adjustment;
The correct pin tension is shown. If you need a larger stitch, the left hand can pull the fabric a little faster. If you need a denser stitch, the left hand can pull the cloth a little slower;
7. change the ball of thread; such as the replacement of large ball of thread, you can spare the extension rod and thread cylinder shaft connection, set into the large ball of thread. The spare plastic cap placed on the end of the rod to fix the large thread ball, and then re-threading, adjust the line tension after sewing; use 50 # - 90 # cotton thread or synthetic thread works well;
8. change the needle: loosen the set screw, remove the broken needle. Shown to install a new needle, pay attention to the flat side of the needle is facing the fixing screws, do not install the reverse.
Notes:
Due to the light and screen setting difference, the items color may be slightly different from the pictures.
Please allow slight dimension difference due to different manual measurement.
1*Portable Metal Galvanic Sewing Machine
This product has no ratings yet.
Subscribe to our newsletter
and be the first one to know about our amazing deals!