MH-CD42 DC 5V 2.1A Mobile Power Diy Board 4.2V

MH-CD42 DC 5V 2.1A Mobile Power Diy Board 4.2V Charge/Discharge(boost)/battery protection/indicator module 3.7V lithium 18650

Product Charging voltage: DC4.5V-5.5V (recommended DC5V) Charging current: 0-2.1A Charging quiescent current: 100uA Full voltage: 4.2V ± 1% Discharge current: 0-3.5A Discharge quiescent current: 50uA Discharge efficiency: up to 96% Output voltage: 5V Output current: 0-2.1A Ambient temperature: -20~+85°C The module comes with a lithium battery protection function (for lithium batteries without protection, with protection board) Overcurrent protection (OCP) Overvoltage protection (OVP) Short circuit protection (SCP) Over temperature protection (OTP) Charge and discharge power level 4 interval indication Pin Description
VIN: The correct input of the charging port + (DC4.5V-5.5V (recommended DC 5V) GND: negative input of the charging port - GND: Lithium battery - BAT: Lithium battery + GND: Output negative output - VOUT: Output positive output + KEY: Output enable trier port (low pulse trier) Note In the discharge mode (the charging mode KEY function is invalid), the KEY port is triered once, and the output is turned on; the KEY port is continuously triered twice, and the output is turned off. When the load is first connected, the output will be automatically turned on. If the small fish 50MA is loaded, the output will be turned off ar 30 seconds; if the load is greater than 50MA, the output will be continuously turned on. Allow one side to discharge while charging (Note: this is the output voltage >4.7/4.7/