Manual Hand Siphon Suction Kit for Universal Car Oil Liquid Petrol nsfer

Manual Hand Siphon Suction Kit for Car Oil Liquid Petrol nsferCondition:100% newColor:Blaand White , nsparent Material:Plastic and MetalSize: showpe Length:approx. 2m(6.56ft) / 4m(13.12ft)Function:for nsferring liquids such as petrol, diesel, oil, water etc.Type:Hand Siphone Item included:

1 x

1 x

2 x Clamp

Compatible With:Universal for cars, trucks, motorcycles

This Is Aftermarket Repment Item But Not

Note:

1) All dimensions are measured by hand, there may be small deviations.

2) slightly due to the color setting of each inp>

Product Dimension:

Attribute:

Feature:

1) According to the factory specifications.

2) High-flow hoses and large-bore ball s faster, and the built-in allows you to siphon liquid from one container to another.

3) Easy to install and use. Just connect the hose and ball , then use the yellow fitting to tighten.

4) Double chevalve design, faster flow rate, two-way chevalve good function, fast oil discharge.

5) It is equipped with two yellow connectors that increase the tightne of the tube and ball to prevent side leakage.

6) Suitable for , oline, crude oil, petrol, oil, water and other common liquids, and it can also serve as a water changer for your home aquarium.

7) Anti-slip and anti-. ble and service life.

8) Stable characteristics, high reliability.

Usage:

1) The correct way to use the suction is to stretch a tube into th you need to and force it first.

2) the flat rubber to expel the air, then immediately blothe outlet of the hose with your thumb, release the rubber , etc.

3) The ball slowly swells and recovers. After th is ed up to fill the rubber , the thumb blocking the outlet is released. Repeated operation 3-5 times forms a continuous s-flow.

4) Directions are used from top to bottom. When using, keep the position of the rubber ball as low as poible.

Tips:

The following conditions must be met in order to remove the car's tank:

1. There is no anti-theft oil filter in the tank.

2. The should be inserted into the tank when ing oil.

3. The tank height must be higher than the oil drum height.