JFIND 2 Automotive Battery Rep Tool ECU Memory Saver Battery Plug Power Supply Cable

Distinctive Features:

1: Compared by most of alligator clip in market with zinc plating, ours are gold plating. Better reliable on contact and electric nsmission.

2: Compared by most of II Memory Saver or Automotive Computer Memory Saver in market with 1 ~ 3 ft in cable length, ours with r 10 ft 3meters cable. In this way, you can change your car battery, also by get the alternative 12V power source from another car, when you not have a jump starter on hand.

3: 8 amp fuse built into the memory saver, better reliable on overload protection.

Product Description:

1: Powered by any jump starter with a 12V outlet into an II Memory Saver.

2: Interface connector between a 12V DC power source and vehicle's II port.

3: Preserves vehicle codes and electronic presets.

The Power Clip onlyThe Extension Cable only:

Full Sets:

Replacing a car battery on older vehicles used to be simple!You unhook the old battery and install the new one. Late-model vehicles, however, rely on computers that operate everything from the stereo to the nsmission. If power is lost to the computer, the settings are lost and have to reset to default. That means the vehicle may feel different when driven, and you may have to enter a security code to access the stereo. Using this simple memory saving device when replacing your car battery will help you avoid these probl.

This device can work with any 12V DC power source, including jump starter, DC 12V Lead-acid battery, or another car’s DC 12V power outlet.

As our device with 3 meter cable, it will be a convenient way, should you not have jump starter or Lead-acid battery on hand, and the device can also get the 12v power supply from arette of another good car. Just insert the arette plug to this car and insert into 16 pin plug to the port of the car you want to rep battery. And now you can rep the battery.

Warning:

1. When working with the vehicle’s battery, review all the battery manufacturer’s and vehicle manufacturer’s safety instructions, warnings and directives regarding battery disconnection, removal and repment.

2. The vehicle’s electrical system is receiving power from memory saver through the connection. Therefore, the vehicle’s battery connectors are electrically live and should be covered with an insulator to prevent the connectors from touching metal or each other and causing a short circuit. After each use, disconnect the memory saver and use a dry cloth to wipe all dirt or oil from the connectors and the cable.

3. During battery repment, DO NOT turn on ignition the car, which its old battery is disconnected and new battery not yet finished repment. As well, DO NOT turn the key on “ACC ON”. If not, the fuse of the memory saver probably out, due to high amp and overload.

4. Security attach the II connector of memory saver into your car II port to get a good contact; if not, during battery repment, the bad contact between the II connector and your car, may cause missing power supply on your car ECU Electronic Control Unit, or called auto computer.

5. The 12V DC plug of memory saver should be correctly connected 12V power source, if not, the red led light on the plug will not light up; that means no power signal from the power source or with incorrect polarity connection. If the power source from another car, then chewhether the car’s arette on good condition or not. If the power source from a jump starter, then verify if the cause is from the contact. If the power source is from an alternative 12V Lead-acid battery, then chewhether the polarity correct or not.

6. The memory saver 12V DC plug contains an 8 amp . Should a problem arise with the memory saver, chethe fuse or contact your direct seller/distributor for istance.