Hot Air Gun 300W Electric Heat Blower Tool Kit for DIY Shrink Wrap Plastic Rubber Stamp with heat shrik tube

# s❤ Main Product:Hot Air Gun❤ Plug Type:EU Plug / US Plug/AU Plug(optional)❤ Heat Gun Power:300W❤ Achievable Temperature:  180-200℃❤ Rated Voltage:EU Plug & AU Plug --220V / US Plug --110V❤ Widely Application:DIY Craft Emboing, Shrink Wrapping PVC, Drying , Clay, Rubber Stamp, etc# About This Item❤ Mini Heat Gun:Dimensions 225x45mm / 8.86x1.77in (Approx.) 3.28FT Long Cable (Approx.)❤ Safety Hot Air Gun:Mini Craft Heat Gun for Epoxy Resin adopts anti-scalding non-slip handles on the outside, independent switch ons, and high-quality stainle steel air outlets and stainle steel brackets inside, ing the use proce safer.❤ Cooling Holes:The temp of the nozzle could reach 180-200° in seconds. The vent at the rear can reduce the internal high temperature and prolong the service life.❤ Easy to Use:The handing part adopts salient point nonskid designs that cause safe handholding with small energizing!# How to Use the Heat Tool★ Plug in the heat tool. Hold the product as shown on the pict.(Do not touch the hot nozzle.)★ Keeping3-5cm distancefrom work and about a45-degree angleto heat until it is completed. (Do not blow the hot air gun directly at 90° to the object.)★ Warm Tips:The temp of the nozzle could reach 200° in seconds, pleasedon't use it for more than 10 minutes at one time.If the temperature of the fuselage increases significantly, please close the heat gun and wait for cooling before using it.Itcan not be usedinindustrial aspects such as disaembly and welding of small iron sheet components and patch integrated circuits.