GTS Powerful Steel with Wire Hair Clipper Hair Salon Special Plug-in

GTS-2800 Powerful Steel with Wire Hair Clipper Hair Salon Special Plug-in Electric Clippers Shaving Hair Trimmer Grooming Kit
Technical :
? 220V/110V voltage
? 50Hz/60Hz frequency
? 10W power
? 46mm width of blade 100Hz/120Hz swing frequency of blade
? Dynamic material: Stainless steel 3Cr13
? Detachable cutter head: not detachable
? Cutter head fine-tuning: adjustable
? Metal upper and lower body: ABS+ bakelite
? Accessories: Comb（3mm, 6mm, 9mm, 12mm), Small Oil bottle, Cleaning Brush
Note:
1、There could be some slight differences in the color tone of the pictures and the actual item.
2、Please allow 1-2mm differs due to manual measurement.
■ How to use:
1.Before the electric shearing leaves the factory, special shearing oil has been filled with the blade part, and the position of the blade and the performance of the whole machine are debugged by professionals.
2.Please empty the machine for a few seconds before cutting a haircut, so that the clipper oil in the blade fully lubricates the contact area of the blade, and at the same time, please pay attention to wipe off the clipper oil oozing from the blade to avoid the clipper oil sticking to the hair.
3.When the electric shears are turned on and off, they will make a “get” sound, and there will be moderate heat and vibration. These phenomena do not hinder the normal use of the electric shears.
4.To keep the electric shears clean, you must always fill the blade with shears oil (shears oil).
5.After cleaning or replacing the blade, the position of the blade must be adjusted to keep the tips of the upper and lower blades flush before it can be used.
■ Blade Adjustment:
If the electric push scissors blade is not corrected well, and the blade needs to be cleaned or replaced during work, the blade must be re-adjusted and proofread. The specific steps are as follows：
1.When debugging the position of the blade, due to the large positioning hole of the blade, the blade screws can be loosened, the position of the lower blade can be adjusted, and the upper and lower blade tooth tips can be aligned in one line.
2.The tip of the upper blade is 0.8~1.2mm back than the tip of the lower blade. This is to prevent the hair from being cut too short or the upper blade from touching the skin.
3. The leftmost tooth of the upper blade must cover the first small tooth on the left side of the lower blade, and the rightmost tooth of the upper blade must cover the large tooth on the right side of the large blade.

1x packages