Please watch the video on your computer, the mobile App does not support playing video, or you can contact us to get the video.PLS!!!

Notice:

1. The glass iscase friendly style,can't cover the whole screen(There is about 2mm gaps at the edges), If you have a case, it will not affect you to use it.

2. The glass is full screen style,can cover the whole screen,The mobile phone case with no edges on the screen can be used.See the illustration below.Please see the comparison diagram.

3.  I suggest you buy full screen style, because it can completely protect your screen from damage, the installationeffect will be better.

Reminders:

1) Please watch the video above before you install this protector! (Very important)

2) If you think the protector is not in best position, you can adjust the angle of the protective film before you use the lamp.

3) There is no strict requirement for glue usage. It is recommended that the S8/S9 uses more than half of the glue; S7 edge, S8 Plus, S9 Plus, Note 8 should use all glue.

4) If you have any questions, please contact us in time and we will help you.

Features:

1. Easy to use and you can reuse it.

2. Full screen and case friendly two styles, for you to choose, I think there is always a kind of you like.

3. The installationtool is a complete set and isvery easy to learn. As long as you watch videos carefully, it's very easy to get started.

4. The glass has a good protective effect. It isfully adhesive and sensitive without dot. It feels the same as bare metal.

5. Anti-scratch, privacy, 3D full cover, HD, anti-explosion, anti-fingerprint oil coating, avoid spots and reduce the fingerprints on your screen

How to install:
1) Use a foil cleaning kit to wipe the phone clean.
2) Place the sticker over the hole in the handset. Stick the key hole with a label.
3) Place custom glue drops on the flat, clean and dust-free glass screes. It is recommended that the glue be poured completely. The excess glue can be wiped clean before turning on the lights. The glue can only be a mass and cannot be separated.
4) The glue that drops on the screen cannot have air bubbles, if there is an air bubble, use the needle to pierce the air bubble to release the air.
5) Remove the release film from the protective film and place the glass on the screen, so that the glass contacts the glue and gently transfers the glass into a suitable position. Do not lift the glass and allow the glass to separate from the glue (very important).
6) Wait for about 30 seconds to let the glue slowly spread and level.
7) If there is glue overflow, wipe off with a clean cloth. After checking the retention criteria for the mobile phone's tempered film, the lamp should be turned back and forth three times around the edge of the phone, and after 3 seconds of initial curing (not in the middle), the edge glue should be wiped again until the glue overflows. (Prevent white edges or long bubbles on edges)
8) Wait for the exhaust to complete. After the glue overflows cleanly and the positioning standard of the tempered film is satisfactory, turn on the light. Otherwise scrap the material.