For Honeywell PTM7950 Silicone Thermal Pad ket 8.5W/mK CPU Thermal Conductive Paste Pad Patch Lightweight for Laptop CPU

For Honeywell PTM7950 Phase-change Pad 8.5W/mK CPU Thermal Conductive Paste Pad Patch Repment Lightweight for Laptop CPUFeature:1. Material:The heat conductive pad is small in size and light in weight, ing it convenient for you to carry and store when not in use. Made of high-quality silicone material, the heat conductive pad is soft and ble, with a smooth surface and exquisite workmanship. With good sealing effect, it can effectively reduce the leakage of liquid during use, and can be used for a long time during refrigerated storage.2. Advanced Technology:Ul high thermal conductivity phase change material (), available in both pad and phase change sheet forms, aims to reduce the thermal resistance of the interface, pa reliability testing, and maintain excellent performance. Based on a new polymer system, this material exhibits excellent interfacial wettability within a typical operating temperature range, resulting in extremely low surface contact resistance, ing it more suitable for today's high-performance notebook computers.3. Reliable:The PTM7950 is a proprietary material that provides excellent reliability (via 150 ℃ baking for 1000 hours, T/C-B for 1000 cycles) and maintaining low thermal impedance, ing the PTM7950 series the best choice for high-performance integrated circuit equipment.4. Ease of Use:It is recommended to use clamping preure and temperature to achieve a minimum adhesive line thickne for thermal interface materials, typically le than 1.5 million (0.038 mm) for optimal performance. Materials must undergo a phase nsition temperature to exhibit their proper properties5. Product Usage:The heat diipation pad is specially designed for CPUs, s, graphics cards, s, power supplies, computer hosts, laptops, and any heat diipation modules you need. Use it to heat your laptop or computer and prevent overheating.Specification:Origin: Mainland ChinaColor: GrayMaterial: SiliconeQuantity: 1 pieceThickne: 0.25mmThermal conductivity: 8.5 W/m-kDensity: 2.8 (g/c)Thermal impedance: 0.04 ℃-cm2/WPhase change temperature: Within 45 ℃Storage method: Refrigerated storageSize: 31x40mm, 40x40mm, 40x80mm, 80x80mm, 80x160mm (optional)Weight: 10gBe careful:This product is a phase change material. During air nsportation, the cabin and local climate may cause slight deformation of the product edges, which does not affect normal use. If not acceptable, do not purchase.Introduction to usage:1. Thoroughly clean the surface of the chip and the contact surface of the radiator. It is recommended to use a complimentary wipe.2. Key points: If the surface of the chip is to be attached, it must be cut to the same size as the chip, or even slightly smaller by one edge, with a solid edge and no overhang, in order to tear the film. If it is attached to the base of the heat sink, it is recommended that it be one circle larger than the chip for easy aiming, and do not cover uneven bumps. Only on a flat surface can the film be easily torn! However, no matter which side you are sticking to, the edges should not be suspended. The next step is easy to operate. Irregular edges and suspended edges can lead to poor film tearing;3. Tear off one side of the release film and paste it onto the base of the radiator or the surface of the chip (do not repeatedly knead the phase change film before use. If room temperature is too high, you can refrigerate it for ten minutes, ing it easier to tear off the film after cooling);4. Then evenly apply preure on the entire surface of the phase change sheet with your thumb to fully adhere the phase change sheet for the next step of film tearing;5. Tear off the other half of the release film. It is more convenient to use the free easy to tear adhesive , which can start from the corners, ing it more convenient;6. Directly install and fasten the radiator, and immediately turn it on for use.Note:Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!Please allow 1-2cm measuring deviation due to manual measurement.1 x PTM7950 thermal pad4 x Easy to tear sticker

.

.