F9T T9B NC 20Gbps Internal USB 3.2 Gen 2x2 20P Type C To Type E Adapter Flat Ribbon Cable USB 3.2 Type C~E for ITX ATX Mainboard A4 PC Case

Brand name: ADT-LINK

Product name: USB 3.2Type-Cto Type-Eflat cable

Product model: UTF3.2-MF/MM-20P series

nsfer speed: USB3.2Standard 20Gbps

Wire length: 3~300 cm, the length can be customized,

Current capacity: 3A within 50cm ; 1.5A within 1 meterProduct application: ITX/ATX motherboard built-in internal 20Pin USB connector or type-e connector, suitable for A4-ITX chais customized side panel USB type-C port.ADT USB series Part-Number Description:

S=USB-A ; C=USB-C ; W=USB-B ; F=USB-E

Cable length Description:

The length of the wire refers to the part of the visible wire. It does not include the and the connector. For the wire length, please refer to the 5cm blue arrow in the figure below.

Product Model description:

Note 1: T6B/T6A/T6A-NC is Type-C sight male;T9A/T9A-NC is Type-C Up angled male;T7B is Type-C sight female;T8T is Type-C up angled female with slotted holeT8T-BK is Type-C up angled female with slotted hole, Baffle;F6A is Type-E sight male connector;F9T is Type-E up angled female connector with slotted hole.Note 2:What is the difference between product model T6A with chip and without chip?

T6A with chip refers to the with RT1710 e-mark chip from RichTek, which supports high current 3A, up to 5A. Compatibility, scalability, and security are relatively good. Support Alternate Mode, Vendor Defined Meage (USB PD)The T6A-NC version without a chip is only suitable for general use and does not support high current. The USB data nsmiion function can still be used normally.

Product image:Product real shot:Summary of technical iues:

1. Can wires and connectors be split?

No, in order to purify the signal nsmiion and avoid the accident of wire falling off, our wire and connectors is and protected by the heat shrinkable tube sleeve, so the product can not be separated.

2. Cable thickne? Can it be bent?

The thickne of the wire is 1.4mm, and it can be bent and folded without affecting the use.

3. Is there any EMI shieldingfor Cable?

No metal shield. The extender utilizes the latest materials for EMI shielding with five sole flat cables design. This technique allows each cable to be fully covered by electroic interference shielding with conducting polymer to guard against incoming or outgoing emiions of electroic frequencies, minimize disturbance and degradation on performance, and reduce the weight of the extender.What is the difference between model UT8T/UT8Q?Model UT8T has no chip, and the signal attenuation after the two USB cables are connected in series may not meet the requirements of USB high-speed signal nsmiion.Model UT8Q with chip using s/Pericom's Redriver IC, which regenerates the signal and enhances its signal quality. To reduce the incidence of signal nsmiion errors, refer to the following schematic: