Electric Scooter Parts Repair 66 Colour Screen LCD Display Panel Accessory For E~Bike Display Meters Acesssories

Note:

Not Universal Model .Please checked and confirmed yours controller support same communation protocol UART NO.2 ,if not same ,The LCD screen will be show Error Core E10 （Communications Receiving Fai）Used Our Store Controller.

Type:FOCAN- LCD display

Condition: 100%

Model :66

Voltage:24V 36V 48V 60V adjust By P03 set on screen

Color:Black

Material: Plastic+Acrylic

Operating Temperature :-20 - 45℃

Handlebar size for holding:Φ22.2mm

Cable length:180±2cm

Plug Type:SM 5pin Connector (LCD cable )+ SM 2pin connector (Light cable)

Communication Protocol:UART NO.2(Note:The product is based on the No. 2 communication protocol and needs to be used with the controller of the No. 2 communication protocol, otherwise it is not compatible.)

Display Funcation :Speed Display, Battery Level Display, Error Indication, Total Mileage, Single Mileage

Package List:

1 x LCD Display

Note: Due to product upgrade, the product you purchased may be slightly different from the descrtions in this user manual, and this won’t affect normal usage.

Set Data

P01:Backlight Brightne (1: darkest; 3: brightest)P02: Mileage Unit (0: KM; 1: MILE)P03: Voltage Cla: 24V/36V/48V/60V (default) /36VP04: Hibernation Time (0: never, other figures refer to the hibernation time) Unit: minuteP05: Aistance: 0,3 gear 1gear2V, 2gear3V,3gear 4V1,5 gear 1gear 2V,2gear 2.5V,3gear 3V,4gear 3.5V,4gear 4VP06: Wheel Diameter Unit: inch Precision: 0.5P07: steel Number (1-100)P08: Maximum Speed Limit Unit: KM/HP08: Speed limit: range 0-50 km/h, 50 means unlimited speed.1. Non-communication state (instrument control): Turn off the PWM output when the speed isgreater than the setting speed; turn on the PWM output automatically when the speed is lower thanthe setting speed, and the driving speed is (+1km/h) at the current speed; (Turn off the speed limitonly for the booster.2. Communication state (controller control): drive speed is maintained at a set value.Error: +1km/h; (Average speed limit of booster and turner)Note: The value here is based on kilometers. When the unit setting is changed from kilometers tomiles, the speed value of the display interface will automatically be converted to the correct value ofmiles. However, the speed limit data set at the menu under the mile interface will not be converted,which is inconsistent with the actual speed limit value of miles.P9: Zero Start, Non-Zero Start Settings, 0:Zero Start; 1:Non-Zero StartP10: Driving mode is set to 0: boost drive (through boost gear to determine how much power tooutput, at this time the switch is invalid).1: Electric drive (by turning the driver, the boost gear is invalid at this time).2: Power-aisted drive and electric drive coexist at the same time (the Zero-start state of electricdrive is invalid).P11: Aist Sensitivity Setting Range: 1-24P12: Setting range of boost start strength: 0-5P13: Set the type of booster disc to 5,8,12 grain sP14:Controller current limit setting default 12A range: 1-20AP15：WITHOUT NOWP16: ODO Reset settings Pre the on for 5 seconds ODO clear