Dual 18650 Battery Capacity Internal Resistance Automatic Charging And Discharging Module Type-C Interface

Product features:

The product supports single- capacity and internal resistance measurement

It supports separate charging and discharging, and supports up to 9 charging and discharging cycles in automatic mode

The stop discharge voltage is adjustable in 11 stops

The internal resistance can be switched between English and Chinese using DC two-wire method

The maximum charge-discharge current is about 1A

Note:

During the charging and discharging process, some components will produce local high temperature. Please ensure that the use environment is open and not covered. If you can increase the heat dissipation of the fan, it is better.

In order to ensure that the battery card clamp firmly, 18650 battery holder uses a compact battery holder, suitable for flat head battery measurement!!

Lithium ferric phosphate does not support charging

How to switch from English to Chinese:

Turn off and press the menu key to turn on

Release the menu on, the English interface will be displayed at this time, and wait for 10 seconds for the system to save

After switching a data, we shut down and restart it, and then switch to English

We turn off and switch bato Chinese, press and hold the menu key to turn on, release the menu key, wait for 10 seconds for the system to save automatically, and then turn off and turn on again. At this time, we complete the switch from English to Chinese.

We turn off and switch bato Chinese, press and hold the menu key to turn on, release the menu key, wait for 10 seconds for the system to save automatically, and then turn off and turn on again. At this time, we complete the switch from English to Chinese.

Basic ：

Working power supply: DC5V power supply or 18650 battery need to bring your own

Applicable battery: meet the stop discharge voltage of 2.5-3.5V, 2.8V start to 4.2V full battery is applicable

Power supply interface: Type-C interface, power supply cable mobile phone cable of port C

System language: Chinese default, English

Test quantity: 1 circuit charging and discharging measurement right side battery only

Internal resistance measurement: Support, use DC two-wire method to test the internal resistance

Charging function: Support, automatically cut off charging when full lithium iron phosphate battery charging is not supported

Discharge function: Support, reach the condition automatically stop, discharge current is not adjustable

Automatic charging and discharging: Supported, the battery is fully charged at the end of automatic mode

Cycle charging and discharging: Supported, adjustable for 1~9 cycles only supported in automatic mode

Status prompt: Supported

Stop discharge voltage: 2.5V, 2.6V, 2.7V, 2.8V, 2.9V, 3.0V, 3.1V, 3.2V, 3.3V, 3.4V, 3.5V, a total of 11 adjustable

Discharge current: two s, about 1A current at most. It cannot be adjusted and does not support independent nsformation

Charging voltage: special battery charging chip control, the maximum charge is about 1A, full voltage 4.2V

Power-off save: Only the Settings are saved, not the metering data

Product weight: 80g net weight 120g including pack

Product size: 110x88x30mm

Package size: 153x100x42mm

Data link: https://www.banber.com/gather/6365d57f9f8cae0007718211.html

Shipping list:

18650 Battery capacity Internal resistance X1