DC5-12.0V Input Voltage ZVS Induction Heating Board 120W

This product is a non-tapped mini ZVS finished-board, induction heating, excluding cooling fan. The maximum is 120W (12.0V induction heating). Push the transformer 12.0V, the primary 10 turns, about 30W. DC5V-12.0V input voltage, this voltage-ranges is working voltage, not the no load voltage of supplys. (The voltage exceeds 12.0V or below 5V, we do not guarantee that it can work normally.) Equipped with blue LED indicator light, if the indicator light is weak, means the supplys is insufficient and you need to replace it with a higher supplys.



Features:

This is a non-tapped mini ZVS finished-board, induction heating, tesla and Jacob's Ladder driver, cooling fan is not included.

The maximum is 120W (12.0V induction heating). Push the transformer 12.0V, the primary of 10 turns, about 30W.

DC5V-12.0V input voltage, this voltage-ranges is working voltage, not the no load voltage of supplys. (The voltage exceeds 12.0V or below 5V, it is not guaranteed to work properly.)

Make sure that all component parts are soldered correctly, the positive and negative poles of the cord are not reversely connected, the load is connected, and then on; do not on at no-load which makes it easily broken.

The width of the object to be heated should be between 1/3~1/2 of the inner diameter of the heating coil, and the width should not exceed 2/3.

The diameter of the heating object should be controlled within 20mm as much as possible, if the heating object is too large, it will be difficult to heat it into red-hot, due to the limited .

The current is relatively large during induction heating, the coil heat is also relatively large, usually work for 5 minutes to off to cooling and please solder the heating coil directly to the printed circuit board during induction heating.

Equipped with blue LED indicator light, if the indicator light is weak, means the supplys is insufficient and you need to replace it with a higher supplys.
Possible reasons for the indicator light not being on are:
1. the line is not connected properly and the supply is not energized.

2. there are components on the board that are damaged.



Specifications:

Name: Induction Heating Board

Input voltage: DC5-12.0V

Maximum :150W(12.0V Inductive Heating)

Item size: 55 * 38 * 1.6mm / 2.17 * 1.50 * 0.06in

Package size: 80 * 80 * 30mm / 3.15 * 3.15 * 1.18in

Package weight: 50g / 1.76ounce



Packing List:

1 * Module

1 * Coil