This website uses cookies
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
In stock
Shipped from abroad
Free return within 15 days for all eligible items.Details
Yankkios
80%Seller Score
35 Followers
Shipping speed: Average
Quality Score: Excellent
Customer Rating: Good
Descrtion: 1: Widely used 2: Small size, mini row booster board 3: Simple to use and easy to understand 4: Large area heat diation 5: High safety performance With EN enable terminal, after the R3 resistor on the module is removed, EN is the enable pin, and the logic is high effective (turn on the boost) and low turn off the boost (low power standby, current le than 1uA). The high level cannot exceed 5V, and the low level cannot be lower than -0.2V. Input voltage: DC3-5V Output voltage: 5V/12V selectable Large output current: 5V3.5A, 12V1A (when the heat diation is strengthened, the maximu.5A is measured when 4.2V is input and 5V is output, but it is recommended to be below 3A for long-term work. Please use thick wires for wiring, and it is recommended to use wires not le than 1.5 square) The output end cannot be connected to inductive loads such as motors, motors, fans, etc.; If the output load is frequently started or frequent large current fluctuations, it is recommended to connect a large-capacity electrolytic capacitor in parallel at the output pad. When the input terminal is a non-battery power supply, it is recommended to connect a large-capacity electrolytic capacitor in parallel at the input terminal. Conversion rate: 95% typical (related to input and output parameters) Quiescent current is le than 1ma Size: 13*21*4.0mm (length*width*height) Output rple: about 80MV Reminder:
The positive and negative of the power supply input cannot be reversed, and the wrong connection is directly sped. The main ch is squeamish and afraid of static electricity. When soldering, try to connect the soldering iron to the ground reliably. In addition, because the module is small in size, but the current is large, you must use a thick wire when wiring. , The thin electronic wire can't reach it!
Package included: 1* DC 3-5V to DC 5V 3A 12V 1A Lithium Battery Step Up Power Module Boost Converter Voltage Regulator Fast Charging Board Stabilizer
About shping
This product has no ratings yet.
Subscribe to our newsletter
and be the first one to know about our amazing deals!