DASH Elow for Impreza GC8 1998~2001 260 km Sound Activated Flame design

** ant notice: The Elow is emitted by AC voltage, the will nsform the 12VDC to 50~75 VAC. Ar connecting to power, don't touch bare terminals or solder points over the output side, will cause uncomfortabel . The natural color of EL (electro-luminescent ) is between blue and green, we design the with high and low frequencies, the high frequency will emit the EL to glow blue color, and the low frequency will emit EL to glow green color. A switch on the er allows you to change frequency /color. However a disadvantage of the design for blue glowing will cause high frequency noise. There is no solution to remove the noise but can minimize the noise by decreasing the brightne or switching to green light section. If the glow is light, the high frequency will emit cold , and low frequency emits warmer light. Before purchasing this item, please consider this fact.

for Impreza GC8 1998~2001 GT Turbo (260KM)

Package inlcudes1 set Elow and 1 piece

This is with meter in KMH (Km/hr)

face. Flame Design.

Sound Activated dancing Flame. Adjustable glow modes: (1)Fullow flame / (2) Sound Activated flame (and when the mic at the least sensitivity, it would look like only the scales glow)

Brightne adjustable thru the controller on the .

Not neceary to remove s for installation.

Anti-glare and scratch resistance surface.

Disconnect the negative terminal on the battery.

Remove screws that hold the bezel and cluster.

Disconnect the wire plugs to the cluster.

Remove the clear cover that protects the s and the blahousing around the .

If there are screws that hold the faceplate remove them.

Gently slide the face over the .  DO NOT REMOVE S!!! Careful s are fragile!

Locate a spot to run wire in the cluster.

Screw in the screws to the faceplate, if removed.

Install back the clear protection cover.

Plug the connectors of faceplates to .

Locate the controller to desire p.

Wiring ground the blawire, and positive red wire to parking light.

Connect the negative terminal on the battery.

Please be informed, you will be responsible for below additional costs happen at the destination.

These are not included in the shping fee we collect, and must be p by receient when the goods have arrived but before delivery.

1. Customs Duties

2.  VAT

3. Other customs-related surcharges

4. Handling Fee (may be requested by some of the carriers)

For detail information, you may contact with your customs office. Thank you.