DASH Brand Elow for E60 M5 E92 E63 M6 330KM 9000RPM BlaPanel Re Light

Things you need to know before buying:

1. Frequency Noise

-The natural color of EL (electro-luminescent ) is between blue and green, we design the with high and low frequencies, the high frequency will emit the EL to glow blue color, and the low frequency will emit EL to glow green color. A switch on the er allows you to change frequency /color. However a disadvantage of the design for blue glowing will cause high frequency noise. There is no solution to remove the noise but can minimize the noise by decreasing the brightne or switching to green light section. If the glow is light, the high frequency will emit cold , and low frequency emits warmer light. Before purchasing this item, please consider this fact.

2. Chethe specification carefully(send us a ture of your , we can help you to check)

The product ture we put on the listing page is exactly the thing we will sh. 

Please compare with your and e sure they are the same. 

Chebelow things match our descrtion and e correct selection. 

- Car model and engine type. 

- Maximum speed and RPM

- Right steering or Left steering car. 

- Automatic or Manual nsmiion. 

for 

for E90/E91/E92/E93 , E60/E61 M5, E63/E64 M6

Maximum speed: 330km,

Maximum RPM: 9000

Package inlcudes1 set Elow   and 1 piece

Product condition: item.

This is with meter in KMH (Km/hr)

Black face. Re glow. Light.

Color interchangeable: No

Brightne adjustable through the controller on the .

removal for installation:No

Anti-glare and scratch resistance surface.

TEST before installation:

Connect each piece of to adaptor that comes with the kit, then test the kit by connecting to 12VDC battery or power supplier.

The adaptor offers 4 plugs, If the kit needs le than 4 plugs, you can cover the unused plug with electric tape.

Do not connect the panel to 12VDC power without the adaptor.

The Elow is emitted by AC voltage, the adaptor() will nsform the 12VDC to 50~75 VAC. Ar connecting to power, don't touch bare terminals or solder points over the output side, will cause uncomfortabel .

Installation steps:

Turn off the car.

Remove screws that hold the bezel and cluster.

Disconnect the wire plugs to the cluster.

Remove the clear cover that protects the s and the blahousing around the .

If there are screws that hold the faceplate remove them.

Gently slide the face over the .

Locate a spot to run wire in the cluster.

Screw in the screws to the faceplate, if removed.

Install back the clear protection cover.

Plug the connectors of faceplates to .

Locate the adaptor and er controller to desired p.

Wiring BLAwire to ground(-, negative), and parallel connect RED wire(+, positive) to parking light / headlight / arette / light er switch which supplies 12 VDC power. If you don't know how to figure out the wires, please let the profeionalism to help you.

Turn on the car and cheif the glow works normally.

Please be informed, you will be responsible for below additional costs happen at the destination.

These are not included in the shping fee we collect, and must be p by receient when the goods have arrived but before delivery.

1. Customs Duties

2.  VAT

3. Other customs-related surcharges

4. Handling Fee (may be requested by some of the carriers)

For detail information, you may contact with your customs office. Thank you.