DASH B~H~K 220 km 6000 RPM for W124 W126 W201 Elow BlaPanel Lighting 1318637K 1303023K~1

** ant notice: The Elow is emitted by AC voltage, the will nsform the 12VDC to 50~75 VAC. Ar connecting to power, don't touch bare terminals or solder points over the output side, will cause uncomfortabel . The natural color of EL (electro-luminescent ) is between blue and green, we design the with high and low frequencies, the high frequency will emit the EL to glow blue color, and the low frequency will emit EL to glow green color. A switch on the er allows you to change frequency /color. However a disadvantage of the design for blue glowing will cause high frequency noise. There is no solution to remove the noise but can minimize the noise by decreasing the brightne or switching to green light section. If the glow is light, the high frequency will emit cold , and low frequency emits warmer light. Before purchasing this item, please consider this fact.

for 6000 RPM, Max speed 220kmWithout Economy )

W124

W126

W201 (190E)

Be aware of these iues before placing order.

Due to various specifications of W124 faceplates, our design may not be 100% same as yours.

Or if your cars are other models with very similar panels of W124, these situations may happen when install our s.

1. Speed scale lines may not match perfectly but a little difference.

2. The fixing tabs are not at same locations or without fixing tabs.

3. The panel sizes are not same, and need some modification.

Package inlcudes1 set Elow   and 1 piece

This is with meter in KMH (Km/hr)

Blaface. Re glow type. light

Brightne adjustable thru the controller on the .

May be neceary to remove s for installation, please operategentlely to avoid damage the s.

Anti-glare and scratch resistance surface. 

Disconnect the negative terminal on the battery.

Remove screws that hold the bezel and cluster.

Disconnect the wire plugs to the cluster.

Remove the clear cover that protects the s and the blahousing around the .

If there are screws that hold the faceplate remove them.

Gently slide the face over the .  DO NOT REMOVE S!!! Careful s are fragile!

Locate a spot to run wire in the cluster.

Screw in the screws to the faceplate, if removed.

Install back the clear protection cover.

Plug the connectors of faceplates to .

Locate the controller to desire p.

Wiring ground the blawire, and positive red wire to parking light.

Please be informed, you will be responsible for below additional costs happen at the destination.

These are not included in the shping fee we collect, and must be p by receient when the goods have arrived but before delivery.

1. Customs Duties

2.  VAT

3. Other customs-related surcharges

4. Handling Fee (may be requested by some of the carriers)

For detail information, you may contact with your customs office. Thank you.