Copy CAME TOP 432NA Duplicator 433.92 mhz e control Universaarage Door Gate Fob e Cloning 433 mhz nsmitter

Duplicator CAME TOP432NA 433.92mhz e control with battery

 Duplicate Your Existing e Control , such as CAME TOP-432NA , and some common fixed and learning code e controls.High quality compatible with CAME TOP-432NA ,CAME TAM 432SA 1. Vehicle cenl locking syst  2. Garage doors  3. Electronic gates  4. Electrical appliances/Home automation i.e. lights5. Car sunroofs  6. Car/Motorbike al Easy to use, the 4 e control system lets you take control of your gadgets,  car, home and garage. Specifications:Operating frequency: 433.92MHzWeight:33g  Size: 55mm x 28mm x 14mmDistance: Up to 100 meters Package included: 1 x RF 433Mhz e Control Battery included ANT NOTE:This item is only 1 piece e control can clone "CAME TOP432NA", just a duplicator ;does not included "CAME TOP432NA" This it send out without retail Package ,but we will pait well before shipped out.How to Program it& x27;s easy!:  Step 1 –delete the existing code  of our e duplicator 1Cliand Hold A and B ons together - Led will f 3 times2Keep holding A on and release B on3Keep holding A on and push B on 3 times, Led will start fing Non-stop Now press any key on the e control, LED lights are not bright, so delete code success; if you press the on LED lamp is lit, indicating that the code is not deleted ! Step 2 -  clone your e 1Put both Into bato Baposition. e sure they have direct contact2Cliand hold 1 on on your e and 1 on on your clone e. Keep holding until led will  e  2 blinks then  3 blinks then goes into Steady and you have successfully cloned. the left keys follow the same above operation If for some reason the clone does not go further then 2 blinks , it means the signal does not go through, please shift the e slowly up and down until you get the point where it wilo through. How to useHow to ProgramOn this product details page there is a video demo to use, but you have to use the computer to see it, you can not see it using your phone.

You can also see the video at this URL:  https://youtu.be/jKkdHoNSuJk

Please use the correct method of use.

  Step1 – delete the existing code of our e duplicator 1 Press and Hold “A” and “B” ons together - Led will f 3 times2 Keep holding “A” on and release “B” on3 Keep holding “A” on and push “B” on 3 times, Led will start fing Non-stopPlease note: during the deletion procedure, e sure to keep the “A” on pressed the whole timeNow press any key on the e control, LED lights are not bright, so delete code success; if you press the on LED lamp is lit, indicating that the code is not deleted ! Step2 - clone your e 1Put both into "bato back" position. e sure they have direct contact.Or the two e controls should be pd as closely as possible put the two e controls on the desktop side by side with zero distance2Press and hold one on on your e and one on on your clone e.Keep holding until LED will e 2 blinks Note: LED 2 blinks not to release onThen 3 blinks then into steady and you have successfully cloned. other ons follow the same above operation If for some reason the clone does not go further then 2 blinks , it means the signal does not go through, please shift the e slowly up and down until you get the point where it wilo through. For the presence of noise, it should avoid interference to operate, If the copy is not successful, it should recopy after clearing code.