This website uses cookies
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
In stock
Shipped from abroad
Free return within 15 days for all eligible items.Details
XiaoCheng
94%Seller Score
50 Followers
Shipping speed: Good
Quality Score: Excellent
Carcardo
30cm x 200cm (11.81" x 78.74") Car Headlight Taillight Tint Vinyl Film Sticker -13 Color option
Please note: If you buy 2 or more quality, we will pack into one parcel to send!!!
Tips:
1.The thickne is suitable for DIY, if too thick, it will not good to operate.
2.This film is suitable for buyers DIY theirs car headlight,taillight,fog light and rear lamp, stick on motorcycle light is also work.
3.The fixed is 30cm. (One full roll is 30cm high and 8 meter long, we just cut it into 30cm high and 2 meter long each order to .)
4.If you buy more than 8 meters, We will send 8 meters and extra meter films to you,
because the length of car lamp films is 8 meter in one roll.
Specification:
Color: 13 colors
Material: Vinyl
Construction: Three layers(Protective layer,sticker and under paper layer)
Size: Width 30cm, Length 200 cm, Thickne about 0.15mm.
How to use??
1.Cleaning the surface with rubbing alcohol prior to installing the vinyl will help with adhesion and clean any contaminants that may cause imperfections.
2.Using a hot air can aid in the installation by making the vinyl more pliable and also help remove wrinkles. 3.Using a soft rubber scraper will help smooth out bubbles and wrinkles.4.Do not let your car to wash or under the sunshine after stick within 24 hours.
1. Cut the righ size according to the car lamp. 2. Cleaning the surface of car lamp. 3. Spray a few water on the lamp. 4. After tore out the back paper, also spray some on the backside of the film .
5. Stretch the film and aim the car lamp. 6. Use the scraper to scrape film bubble. 7. Use a 2000W hot air or hair dyer to blow dry will make it more paste , and the angle more perfect ! 8. After blow, use the the scraper to scrape the angel position.
9. Use a cutter along the car lamp to rthe extra part. 10. A great DIY was done!!!
About shipping
This product has no ratings yet.