Car Front Headlight Gl Cover For BMW X1 E84 2010~ 2015 Left Right Side Repment Lampshades Car Clear Shell

Please carefully cheif the lampshade matches the vehicle when placing an order. If you are unsure, you can take a photo of the vehicle and send it to me

Specification:

Fitment:For BMW X1 E84 2010 2011 2012 2013 2014 2015

Material:PVC

Color: nsparent

There are three types of pasets, paaccording to your selection

1.Package : Left*1

2.Package : Right*1

3.Package : 1 Left + 1 Right

Installation instructions for lampshade(If you don't know how to install it, you can go to a car repair shop)

1. If you have oven, as as remove the lamp bacover, , and then put in the oven temperature to 80 degrees, heating for 10 minutes, the will son, lampshade and shell is easier to separate

2. If you don't have an oven, you can only a hot air . The hot air first heats the sharpest corner of the headlight, slowly heating it bit by bit, soning it, and then inserting it with a flat screwdriver. Please be careful not to too much force to avoid damage. When heating until it feels a bit hot when wearing , stop! (Note: The temperature should not be too high to prevent damage to the headlights)

3. Ar heating, quickly and forcefully se the corner. Be sure to wear to se, and the should not shed hair to avoid exceive force

4. Experienced and proficient, one minute is enough from heating to peeling off. If it doesn't go smoothly, continue to heat the separated area with a hot air , and when the sons, it will be easy to peel off with hand force

5. Clean the in the rear shell sink as much as poible, wear , and then remove the decorative frame from the lampshade and install it on a new lampshade

6. Cover the with a pointed lid and sciors to cut open the lid (note that only a small diagonal opening is needed). Apply into the groove (if the flow rate is too small, cut it larger), ensuring that the reaches half to two-thirds of the height of the tank (do not break the , try to ensure consistent height)

7. Pre the new lampshade onto the bashell. If any adhesive is found to be leaking, it can be left untreated for now. Ar the adhesive dries out, everything will fall off with a . If there is adhesive on the surface of the lampshade, we it with a cloth to clean it

8. Note: We suest that you air dry the car in a ventilated envment for three to five days before installing it. Do not wash the car or get caught in the rain for a week to avoid water infiltion

Note:

1.Light shooting and different displays may ca the color of the item in the ture a little different from the real thing.

2.Please e sure this item will fit your vehicle before you purchase.

3.Due to age, some vehicles will require new weatherstrping behind these .