AER Automotive Electric Circuit P100 PLUS Car Electrical System uilt-in Flight Power Circuit Probe Kit

AERmotor P100 PLUS Circuit Automotive Power Circuit Probe Kit Built in Flight Electrical System Tool  Features DC voltage range: 0-65VResistance range: 0-100 kΩRated current: 1-10 amps Frequency response of sound page: 0Hz to 10Khz. 

Perform current injection, measurement, ground test, polarity test, continuity test and component activation.

Ergonomic housing design with waterproof, rued, blow-molded housing, easy to handle and store.

There are 4 modes to diagnose the electrical syst.DC voltage, AC voltage, Resistance,

AC- RMS, AC peak to peak, frequency and width for signal testing.

High voltage capability: displays up to 60 volts, 0.1 volt resolution.

8-amp circuit breaker, automatic reset, no on to press.

Three additional modes: MIN / MAX / audible monitoring.

Automatically detects positive, negative and open circuit.

Large color screen LCD with easy to user menu.

Comes with an additional 20ft extension cable.

Find shorts to ground and to voltage.

Find The Short Circuits

In most cases, a short circuit will appear as a blown fuse or a tripping of an electrical protection device.Use the probe tip to activate and energize each of the fuse contacts..The contact which trips the circuit breaker is the shorted circuit.

Find The Bad Ground

Probe the suspected ground wire or contact with the probe tip. If the circuit breaker tripped, this circuit is more than likely a good ground.

Testing iler Lights

While the tool in DC Voltage mode, clip the auxiliary ground lead to the iler ground , probe the contacts at the and then apply voltage to the probe tip. This lets you chethe function and orientation of the connector and iler lights.

CheContinuity

While the tool is in Resistance mode, using the probe tip with chis is ground or the auxiliary ground lead, continuity can be d on wires and components attached or disconnected from the vehicle’s electrical system.

Activating Component

The component activation function is designed to generate activation signals to the d components, such as activating lights, motors and other on-board electric equipments.

Signal Circuit Testing

Once you exct a DTC from the vehicle and realize that troubleshooting begins with some kind of r circuit, there is a quitest you can perform to verify the code. Testing your r is easy while using the tool.

Voltage & Polarity Testing

While the tool is in DC Voltage mode, contact the probe tip to a POSITIVE circuit. If contact the probe tip to an OPEN circuit, neither of the LED will light.

Package List

1 * AERMOTOR P100 Plus Circuit