60W 80W 100W Water High Pressure Diaphragm Water DC 12V 24V S Priming Automatic Switch Irrigation System Tools

Name: Micro Diaphragm

60W 80W 100W

12v-60W 80w
12V-100W
24V-100W

60W 80W 100W, power maximum output:

Maximum output water pressure: 0.8Mpa

Flow rate maximum: 5L/min

100 watt , power maximum output:

Voltage: DC12V-8A

Voltage: DC24V-5A

Working pressure: 7-11kg

Flow rate: 8L/min

Note: The correct power supply must be matched

Filters must be used at the ennce

Connection thread: 1/2 "18mm" connection hose 3/8 ""

Function:

1. Pressure switch type: when the outlet is completely blocked,

When the set maximum pressure value is reached, the 60w 80w power supply will be automatically cut off.

The motor stops and restarts before running.

100W, cannot be turned off automatically, need to cut off the power.

The hose hole should not be too small, otherwise it will damage the pressure switch in the .

2. The mounting feet are made of rubber instead of hard plastic, which can provide good ion isolation.

3. Connect the water inlet and outlet to the silicone PE or pu .

Frequently Asked Questions

Is the ringing? If it does not absorb water, will it at idle speed?

The has a certain noise when working, about 70 decibels. The water inlet adopts hose, and the is fixedly installed to reduce noise. Not idling for a time will not damage the , but it is not a good idea to let the dry for too long.

Is the water?

Each has been d before leaving the factory, so there will be clean water in the water, and there is a red waterproof cap on the thread to prevent the from g too dry and not absorbing water for a time.

What motor is used in the ?

Full copper wire double-roller DC motor power cord is not divided into positive and negative poles, continuous service life exceeds 1100 hours

Note: The size is measured manually, please allow slight measurement error.