6 gang 12-24v sp5106 universal waterproof panel box kit led push button switch panel for car RV truck Marine Boat Caravan

Sp5106 universal waterproof panel box kit 6 gang 12-24v led push button switch panel for car RV truck Marine Boat Caravan

Feature:

1. Ultra-small panel size (60% smaller than traditional panels).

2. Easy installation-no installation depth, minimum drilling (13x8.5mm/0.51x0.33in).

3. Using a compact, easy-to-access micro USB cable, the end user can rep the cable to any desired length.

4. Flexible wiring-the control relay box is installed at a distance of 1 meter from the touch screen.

5. IP66-strong water jet protection (only applicable to the panel).

6. Indicate LED / 10A self-resetting fuse for each branch.

7. The backlight module is easy to operate in the dark, and the stand current is extremely low (90% lower than the previous model).

8. All buttons can be programmed as instant (ideal horn or wiper application).

Includes a set of various graphic labels and stickers.



Specification:

Product : 6P membrane panel switch 12-24V universal set

Product model: SP5106

Panel size: 9.1x0.8x7.5cm/3.58x0.31x 2.95in

Control box size: 16x9.5x3.2cm/6.3x3.74x1.26in

Packing size: 9.8x6.1x19.9cm/3.86x2.4x7.83in

Product net weight: 303g

Product gross weight: 344g

Product voltage: DC11-30V

Product current: 10A per branch circuit

Panel: PET film touch screen

Circuit protection: Built-in resettable fuse (PPTC)

Switching rating: 10A per branch

Panel rating: Maximum cumulative amplifier: 35A

Rated voltage: DC 11-30V

Protection: IP66 (panel film)

Power terminal: M4 stud size ring terminal

Loading terminal: .250 fast terminal (male)



Installation Notes:

1. P the provided template on the desired panel position and cut the holes accordingly.

2. From the back of the dashboard, insert the micro USB plug to the front. Connect the micro USB plug to the socket on the back of the panel.

3. Install the panel firmly on the dashboard, and use self-adhesive on the back of the dashboard.

4. Install the control box correctly with the included screws.

Insert the other end of the micro USB cable into the control box. Insert the cable into the strain relief hook on the box.

5. Press the DC positive wire ( ) tightly with the included round terminal. Pass wires through the included insulators and connect to screw terminals. Cover the terminals with insulators. Clamp the DC negative wire (-) with an insulated 0.250" female terminal, and insert it into the negative quick terminal on the control box.

Connect the load terminal to the required equipment. The numbers on the top of the load terminals correspond to the numbers on the membrane contact 1 2 3 panel shown on the left.

6. (Momentary button setting) Set a specific button as momentary (press), press the button and the backlight button at the same time for more than 5 seconds, until the button flashes. All buttons can be set to be short-lived. To undo this action (change the button to on-off), simply repeat the process again on the same button.



Note:

Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!

Please allow 1-2mm measuring deviation due to manual measurement.








1set X Switch Panel

There could be some deviations due to manual measurement or slight color difference owing to photographing condition. Thank you for your understanding. If you do not understand what you can contact customer service at any time, I wish you a happy shopping.