5C3Z-9D930-A 5C3Z9D930A Engine Module Wire Harness For Ford F250 F350 F450 F550 6.0L 03-07 Powerstroke Diesel FICM

About this item:

HIGH-DUALITY MATERIALS: OEM-compliant harne are constructed with high-quality materials that will not become brittle when exposed to extreme engine temperature.If your truhas a jetting fault code, idling or not veling smoothly, please cheand rep the harne in time to allow 6.0 Powerstroke to run normally.

REPS PART: The control module harnees are a direct OEM repment,ing installation quiand easy.

ENSURE THE RIGHT SINGNAL: The harne' electric terminals are constructed with an aluminum material that is resistant to oxidation ensuring proper signal is maintained to the .

WELL CONNECTED: The harnees use a high-temp Viton o-rings which enable prolonged sealing of electrical connection under extreme heat conditions.

Reps part numbers:5C3Z-9D930-A / 5C3Z9D930A / 9D930

Fitment:

For 2005 Ford Excursion V8 6.0L Diesel Ford OEM 5C3Z9D930A

For 2005-07 Ford F250 r Duty TruV8 6.0L Diesel Ford OEM 5C3Z9D930A

For 2005-07 Ford F350 r Duty TruV8 6.0L Diesel Ford OEM 5C3Z9D930A

For 2005-07 Ford F450 TruV8 6.0L Diesel Ford OEM 5C3Z9D930A

For 2005-07 Ford F550 TruV8 6.0L Diesel Ford OEM 5C3Z9D930A9

(This is fits all Ford Powerstroke Diesel engines designed for 05-07 trucks, but will fit 03-04 trucks also. This harne is different but will work on 03-04 model trucks.)

Note of Repair:

The wiring harne holds the wires of the . Though wiring harnees are high-quality components that take a time to wear out, they'let damaged eventually. When that happens, you have to be ready to rep the wiring harne of your vehicle right away. If you're driving a vehicle that's equipped with a max LLY , here are the things that you can do to rep the damaged wiring harne.

1.Park your vehicle, and turn off its engine.

2.Open the hood, and locate the fuse box in the paenger's area.

3.In order to relieve the preure in the system, carefully remove the fuse.

4.Carefully disconnect the negative cable from the battery.

5.Find your vehicle's s. Usually, these components can be found in a spot where the engine blois connected to the line. Depending on the engine size, your vehicle might have several s.

6.Find the old wiring harne. Chefor rust, cracks and dirt. If the wiring harne isn't able to hold all the wires properly, then rep it with a new one.

7.Push the center of wiring harne to release it from the . e sure that you slide the old wiring harne down the line.

8.Depre the clip that slides over the old wiring harne so you can release it from the line.

9.Put the new wiring harne in p by sliding it onto the line just beneath the clip. You should be able to hear a clicking sound once the new wiring harne is secured.

10.e sure that the line and the wiring harne is aligned with the corresponding .

11.Secure the new wiring harne by preing the clip that will hold it on the .

12.Reinstall the fuse box and reconnect the negative cable to the battery.