433Mhz Remote Control Switch AC220V 30A Hign Power On off Remote Control for Water Pump Motor LED/Electric Appliance

Specifications Of The Transmitter




Remote control Transmitter




Operating voltage:DC12V(23A/12 battery x1)




Transmitting frequency:433MHZ




Encoding Type: Fixed code




Receiver sensitivity:>-105dB




Transmission distance :100M(Open field)




Size:approx 66*28*29mm




Specifications Of The Receiver:




Operating voltage:AC 110V-240V




Output voltage = Operating voltage




Operating frequency:433MHz(Same withRemote control)




Encoding Type:learning code




Rated contact current of relay:15A/240VAC,15A110VAC (Please notice that :Although the relay is

marked 30A 240VAC.The 30A is for the peak currentof your load. The rated current of your load should lessthan 15A)




Box size:Approx 65x45x28m

Operation Introduction:




About Working Mode:




Momentary: Press the remote button, the relayconnects,release the remote button. the relaydisconnects.




Toggle: Press once the remote button, the relayconnects,press the remote button twice, the relaydisconnects.




Latching:Press the remote button A, the relayconnects,press the remote button B, the relaydisconnect.




Clearing the Code:




Press the Learning Button on the receivers for 8times, the codes will be cleaned.




After cleaning the code, all the remote control cannotwork any more.




Learning the Code:(Momentary)




Press the learning key on the receiver once time, itcomes into momentary setting mode.




Wait for a moment, the LED will be off ,it comes intolearning state.




Push the remote button, LED indicator on the receiverboard wil flash then come off.




After 3 seconds, the LED indicator will be on againlearning successfully.




Learning the Code: (Toggle)




Press the learning key on the receiver twice time, itcomes into toggle setting mode.




Wait for a moment, the LED will be off ,it comes intolearning state.




Press the remote button, LED indicator on the receiverboard will flash then come off.




After 3 seconds, the LED indicator will be on again,learning successfully.




Learning the Code:( Latching)




Note: When you choose for latching mode, in order tolearn more remote control, you need to learn twodifferent button, the first time learning is for ON, thesecond time learning for OFF.




For example: Button A=ON,Button B = OFF




Press the learning key on the receiver triple time, itcomes into latching mode.




Wait for a moment, the LED indicator on the receiverboard will flash then come off.




Press the remote button A. LED flash for 5 times.




Press the remote button B.LED flash for 5 times




After 3 seconds, the LED indicator will be on againlearning successfully.




A = ON, B = OFF




About Delay:




1.Learning method with a 5-second delay




Press the controller learning button four times, theindicator light flashes four times and then press theremote control to send a code, the receiver indicatorflashes three times and then the learning is successfulthen press the remote control to send the code, therelay will automatically disconnect after 5 seconds ofclosing.




2.Learning method with a 10-second delay:




Press the controller learning button five times, theindicator light flashes five times and then press theremote contro to send the code,the receiver indicatorflashes three times and then the learning is successfuthen press the remote contro to send the code.andthe relay will automatically disconnect after 10seconds




3.Learning method with 15 seconds delay:




Press the controller learning button six times, theindicator light flashes six times and then press theremote contro to send a code.the receiver indicatorflashes three times and then the learning is successful.then press the remote contro to send the code.andthe relay will automatically disconnect after 15 secondsof closing.