433MHz AC 110V 220V Wireless RF Remote Control Switch 1CH Relay Receiver With ON OFF For Led Bulb DIY Control

Note:

The relay controller is RF Receivers ,the wall switch is RF only. Wall switch itself cannot control lights on off. It needs to work with rf receiver together.





Relay Receiver Board Parameter
Working voltage : AC 85V~240V
Quiescent Current : 97dbm
Amount of storage remote controls : 20 pieces
Support encoding : EV1527 Leaning code
RF Operating mode : ASK superheterodyne wireless reception
Receiving range : Open space is more than 100 meters
Remote operating mode : Toggle Mode / Latched Mode
Easy connect and multi control one
The receiver is easy to install, Multi switches can control different receivers or one receivers

strong signal and Long distance control
Control the light in the room, even outside the room, The receiver can be remotely controlled up to 100 meters through a wireless switch and the signal can be controlled through the wall

Wide range of application
Products can be used in homes, farms, factories, offices, laboratories, supermarkets, and so on
Remote control Water pump \ Fan \ Lamp \ LED light \ bulb \ ventilation device\ Exhaust system, Kettle, water heaters \ Signal transmission \ Electrical equipment
\Factory Home Office Ventilation Pump LED Light




Smart Home, Feel free to use it together

Learning Pair Code
it can work with any remote control with the same frequency, so you needn't worry about losing remote
control any more.(if the remote control is lost, buy one and pair with the PCB board is Ok )


How to get the signal

Step 1: Press the learning button(on the Receiver) twice. Wait for 3 seconds;

Step 2: Press one button on the remote control or wall panel. Wait for 3 seconds. Succeed.

How to clear the signal

Only one step: Press the learning button(on the Receiver) 8 times. Wait for 3 seconds;

Package including

1*Remote Control+1*Receiver / Only 1*Receiver / Only 1*Remote Control
(It depends on the model you choose)