315MHz 433MHz Copy e Control 433MHz Learning e Control Code EV1527 RF nsmitter For Gate Garage Door Alarm Receiver

1. The e control is Learning Code Type ,but not copy type. It need to work with the 433mhz receiver or relay module.

2. If you want the e control match with your receiver module,they need in the same conditions : 433mhz & EV1527 learning Code.

Model Number: Wireless e Control

Wireless Communication:RF

Frequency:433 MHz

Input Voltage: 12 V

Receiver sensitivity: > 97 dbm

nsmitting distance:> 100 m open space

De mode: MCU de

e storage: 20

Support e type: EV1527 learning code

Working mode: Momentary, tole, latching time delay 5s ,10s ,15s

Output terminal: NO , NC , COM
Package included

1* RF 433 Mhz e Control with battery

e control battery: 2 x 3 V CR2016 on batteries

Note: Maximum input power is 250 V

e prograng

-Clearing the code :

Push the learning on on the receiver 8 times , the codes will be reset.

After clearing the code, will be need to be recalibrated

-Momentary mode

Please contact us for detailed use instructions

-Learning the code : Tole - Press e on to turn on, press again to turn off.

Press the learning key on the receiver 2 times, Wait for a moment , the LED will be off , it comes into learning state .

-Push the learning key on the receiver 3 times , the LED on the Receiverwill blink 3 times.

When the LED is on, press the on of the e controlYou want to let it learn, Push the e on A, LED f for 3 times .

Push the e on B, Led f for 3 times .

After 3 seconds , the LED indicator will be off , Learning to succeed.