12V Car Dual Push on Switches LED LIGHT BAR FRONT REAR CAMERA For Toyota 4Runner Hilux Pdcruiser 4Runner

This is a high quality 12V 3A combination switch. It is one of theMUST HAVESfor your vehicle modifications, especially when you have limited space or wish to maximize your existing OEM switch locations. You can install without the need to damage your vehicles dash by addtional holes. This dual switch has a surface size of 39mm x 21 mm (1.54"x 0.83") and uses the mounting hole of the vehicle. It gives you a clean and style look.

Single Input Dual Output

Led: Green ON, Red OFF

The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the acceory MUST be wired through a fused relay.

Wiring cable is included

High quality single pole single throw ON-OFF push switch

Face surface size: 39 mm x 21 mm ( 1.54" x 0.83"), Uses the mounting hole of the vehicle

Switch cutout required for the other acceories is about 17mm x 36 mm ( 0.67" x 1.42" )

Upper light is ON when the switch is preed IN; Lower light can be wired to separate dash light circuit

These switches are an armarket switch that locks into your existing panel r easy to install in le than 10 min's

All symbols are Laser etched directly onto the switch face using modern high Tech laser equment to ensure image life.

This Switch Suits the following models :Additional vehicles that are not listed may be suitable for these switches. Please CheSizing

For Toyota P 120 Series 2003 - 2009For Toyotadcruiser 100 Series 1998 - 2007For Toyotadcruiser 75, 76, 78, &79 Series New Model Platic DashFor Toyota FJ Cruiser 2007 - 2018For Toyota Hilux KUN26R, N15R, N25R 2005 - CurrentFor Toyota Tacoma 2005-2011For Toyota Tacoma 2012-2015 ( Left Side ONLY )For Toyota For 2005-2014For Toyota Highlander 2001-2007For Toyota Tundra 2005-2007 ( Center Console if existed )For Toyota 4Runner 2003-2009For Toyota HiAce 2005 - 2013For Toyota Kluger 2001 - 2007