10pcs 433mhz e Control Smart Copy Duplicator Electric Garage Door Gate e Cloning

 

Cheyour device Frequency and IC chip model before buying

Must be meet the following three conditions:

1.You must have a good e controller.Or will copy the bad command, can't work

2.You need to know the device frequency and IC chip model of your current e controller.

3.This e controller is mainly suitable for rolling door, rectable door, Road gate, etc.

 

If your door is a re door, you 'd better confirm it with our customer service before purchasing.

 

For example: open your e controller and chedevice frequency 433, IC chip model is 2264, and you also have a usable e controller, will be ok to choose this product. 

 

Compatible IC chip:2260as,PT2260,SC2260,HS2260 LX2260,HX2260; 2262as,PT2262,SC2262,LX2262,HS2262,HX2262, PT2264,PT2240LX2240 LX2241 SCL2240,CS5211,1527 EV1527,HS1527,HX1527 SC1527 GP1527 CP1527 AD1527 SCL1527 TL1527 ZX1527,SMC918,AX5026,SMC926,AX5326-3,AX5326-4, FP527,HT600,HT680,HT6207,HT6010,HT6012,HT6013,HT6014,HT12D, HT46F49E, PIC16F630 ULN2003, etc.

 

RF frequency type: 315/868/433 Listing product only support 433.92 MHZ

Duplicate Your Existing e Controllers so you always have a backup: 

1.Vehicle cenl locking syst   

2. Garage doors   

3. Electronic gates   

4. Electrical appliances/Home automation i.e. lights 

5. Car sunroofs   

6. Car/Motorbike al 

 

Operating Current: ≤12mA

Operating frequency: 433.92Mhz

nsmitting power: ≥10mW

nsmission Distance: 50 meters open

Frequency deviation: ± 0.2MHz

nsfer rate: 50--60KHZ

Working temperature: -20~70Celsius

Storage temperature: -10~ 50Celsius

Humidity: 85% or less

How to use the e control
1. Code clearing method:

At the same time, press and hold the two keys of unloand unlosome shells have two keys of up and down, and the LED indicator enters the fast fing state. At this time, all the data in the memory is cleared. After clearing the data, the e control will not light up no matter which key is pressed.



2. Copy method:

One hand holds the e control and the other hand holds the copy e control. The two e controls should be as close as possible. Press the keys required for the copy respectively, and the LED indicator will f quickly after fing. The copy is successful. The other key operation methods are the same. Some e controls have low nsmission power, so the e control and the copy e control should be operated bato bato e the copy. If there is interference in some operating environments, the interference operation should be avoided. If the copy is not easy to use, the copy should be repeated after the code is cleared. Especially ant: the e control on your hand must work normally and have the same frequency as our e control

Package Included:
10 * 433MHZ e control Icaning battery included