10M Bandwidth 100X Oscilloscope Differential Probe DDS Gain Split Probe Signal Amplifier for Weak Electrical Signal Measurement

10M Bandwidth Oscilloscope Battery Powered Oscilloscope Acceories Low Noise for Maintenance Personnel for Electronic EngineersFeature:1. Optional :Signals Amplifier supports differential input and single-ended input, with a wide input voltage range and a maximum of+/- 10V. 1x/10x/100x selectable , up to 10M bandwidth.2. Variety of Charging Methods:The Signal Measurement Tool can be powered by batteries, and supports USB and TYPE C interface charging.3. Ultra-low Noise:The Weak Electrical Signal Measurement Tool has ultra-low noise, high common-mode rejection ratio and long battery life.4. Durable Material:10M Bandwidth Oscilloscope exquisite metal shell, strong anti-interference ability.5. Versatile:Weak Signal Amplifier is widely applicable in the academic experiment, electronic product design,debugging and maintenance, electronic engineering education, etc.Specification:Origin: Mainland ChinaOscilloscope Parts & Acceories Type: Oscilloscope PartsSingle-end input voltage: - 10V to+10VDifferential input voltage: - 10V to+10VSingle-end input impedance: 2MDifferential input impedance: 4MOutput voltage: - 10V to+10V: 1x/10x/100xBandwidth:G=1-10MG=10-10MG=100-2MCommon mode rejection ratio:>80DBNoise: 5nV/ 1KHzPower supply: built-in rechargeable lithium batteryCharging interface: USB TYPECBattery life: about 5 hoursOperating temperature: 0 °C-40 °CWorking humidity: ≤ 90% RHPower consumption: ≤ 0.2WVolume: 115 * .5 * 21mm/4.5*1.9*0.8inNote:This product is specially designed for amplifying weak signals. For weak current, the noise is small, the accuracy is high, and the signal is well recovered.The oscilloscope is usually unable to measure small signals, and the instrument needs to be amplified before measurement.It can also be used for industrial automation measurement and control because the sensor signal is very weak and needs to be amplified before output.This product is not a high preure probe. The high preure probe is used for high preure operation. For strong current, it is generally used to measure high voltage, and the accuracy requirement is not high.Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!Please allow 1-2cm measuring deviation due to manual measurement.1 x 10M Bandwidth Signal Amplifier1 x 0.5m BNC straight cable1 x BNC short-circuit cap