1 2 3 5 10PCS ELRS 2.4G Mini Receiver ExpressLRS 2.4G NANO EP1 EP2 RX Long

The CYCLONE series receiver is based on the open-source architecture and program of ExpreLRSI. ESP8285MCU is used. You can upgrade the firmware through WIFI, which is very friendly. Usually, you only need to power up the receiver and turn off the e control. By default, you can find the hotspot of LExpreLRSE 60 seconds later. Connect to the hotspot through a computer or mobile phone. The key is expreIrs. Then you can acce 10.0.0.1 to upload the receiver firmware.

Nano 2400RX receiver with power amplifier (PA+LNA). Therefore, it has 100mW telemetry output and better sensitivity at longer distances. It uses EX1 1st generation pedestal and external T (customized by profeional factory, each has been tested by a profeional device to ensure quality, lightne and durability).

Because of the low latency and high refresh rate RF modules of the ELRS Nano receiver, they are very suitable for competitions and long-range. At the same time, these receivers have ultra light and ultra small dimensions.

Nano 2400RXFirmware: BETA 2400RXType: ISM Interface: EX1Max Refresh Rate: 500HzMin Refresh Rate: 25HzWorking Voltage: 45.5VWeight: 0.65gSize: 17mm*10.5mm*3mmProtocol: CRSF (Betaflight)

Product List:Nano 2400RX *1T *130# connecting wire *4 (black, red, white, yellow)Heat Shrinkable Sleeve *1

Configuration & Bind:

1. Please check the software version number of the ELRS module or the built-in ELRS module first. At present, there are only general version numbers of 1. x.x or 2. x.x. Please confirm that the module and receiver are the same general version. (For example, the module with version 2.0.1 can be used normally with the receiver with version 2.3.0, so it is not neceary to upgrade the module firmware.) However, for better compatibility, it is recommended that the module and receiver be upgraded to the same version.

2. The LED will start to double flash after the receiver is powered on and off for three times, which means the receiver enters the frequency matching mode. Enter Module Binding operation.

3. After the setting is succeful, the LED on the receiver will become normally on, and the telemetry signal can also be received.

4. Meaning of receiver LED status:

The LED is always on, indicating succeful frequency matching or normal connection and communication

The double flashing LED indicates that the frequency is being aligned.

The slow flashing LED indicates that the transmitter signal cannot be received.

The rapid flashing LED indicates that the wifi communication mode can be updated through the computer or mobile phone.

About shping
Shping and Packaging All it will be double checked and well packed before sending.It will be dispatched within 2 business days after buyers pay for the order. It usually takes about 14 to 18 working days for delivering the package to the destination(for e areas,it may take a little longer). 

Special Announcement:
Please fill in the correct and detailed consignee, address and phone number in the order. For fast and correct delivery.If you do not receive order within 30 working days,please feel free to contact Customer Service before leaving Negative and Neutral Feedback, we will do our best to help you resoe the problem.TaxNo, you will only pay what is quoted as total cost at checkout, no more. You are not expected to pay any additional duties or taxes. If you are asked by Customs or our logistic partner to pay duties, please contact our Customer Service .

Your 100% satisfaction is very ant to us
If the product is not on good condition, You can return this product within 14 working days, please contact customer service center before returning.FeedbackYour satisfaction is our first priorityIf you receive the order and it is in good condition,we would be grateful if you would leave us 5 star Positive Feedback for the transaction.