915 Generation Fully Assembled DIY Kit Oscilloscope Teaching DIY Digital Oscilloscope Kit Upgrade Version with BNC Probe

Adopts ARM - processor and includes a 24-inch color TFT display screen
Used for secondary development on the basis of this kit for example it can be changed to millivoltmeter data loggers
Come with instructions easy to install and operate
Autonormalsingle trigger modes easy to capture the moment waveform
Available rising or falling edge trigger

Observable previous waveform trigger negative delay
Can freeze waveform display at any time HOLD function
Waveform parameter digital display including frequency period duty MAXMIN-virtual values
Short-circuit and open-circuit detection Can help the find out the soldering error
TFT controller recognition function
The SMD has been soldered more suitable for electronic beginners
Maximum real-time sampling rate 1 s
Analog bandwidth 0 - 200 KHz
Sensitivity range 5 - 20 mV
Maximum input voltage 50 Vpk 1X probe
Input impedance 1M ohms20pF
Accuracy 12 bits
Record length 1024 points
Coupling modes DC AC GND
Time Base Range 500s - 10us
Trigger modes Auto normal and single
Trigger position Center of buffer
Supply voltage DC 9 V 8 - 10 V
Current consumption ~120 mA @ 9 V
Main board size 94 x 65 mm 37 x 256 in
Analog board size 65 x 47 mm 256 x 185 in
Screen size 52 x 40 mm 2 x 157 in
ColourWhite
MaterialABS
Different batches the product may have color difference does not affect

Package Contents
1 x oscilloscope
1 x BNC probe

Only the above package content other products are not included
Note Light reflection and different displays may cause the color of the item in the picture a little different from the real thing The measurement allowed error is - 1-3cm