Dental Lab Model System for Laser Pin Machine Instrument Tool Dentist

Features:
1. and high quality.
2.Dental lab Model system item.
3.: White
4.Material: High Quality Plastic

Usage:
Step 1: Cut the elastic impression in such a way that all parts which stand out at the bottom of elastic impression and which are not needed(e.g.duplication folds)are removed. For maxillary elastic impresssions the palate arch needs to be flatted.
Step 2: Mount the cuff to the base plate and insulate the base plate with the insulation spray enclosed for the model system . Spray on an even film of insulation. Turn the pins will be covered by the insulation. Insulation should be dry before pouring in the . While the insulation is drying(duration of approx. 1-2min)disinfect the elastic impression as usual.
Step 3: Pour out the impression as usual and fill the pin base plate with plaster just above the pin level. The elastic impression which has been poured out is now positioned on the pin base in accordance with the base.
Step 4: After adhering the setting time started by the corresponding plaster manufacturer the casting is removed from the elastic impression. The white cuff is removed and the pin base plate is lifted from the spilt cast plate in order to enable access to the bores for the lifting devices.
Step 5: The lifting device is inserted in the respective bores at the bottom of the pin base plate. By means of the lifting device the tooth is cafefully lifted off, and by doing so the cover of the model system will loosen. Make sure whether there is tilting of the part, just remove the lifting device and try the lifting again. Make sure, that you be careful in lifting the model.
Step 6: Grind the tooth from the vestibular with a dry trimmer or a wet trimmer until the first row of pin holes is exposed. Clean the pin holes(e.g.steamer) when using a wet trimmer before you replace the tooth on the pin base plate. Form oral, a tooth grinder or a pointed is suited for grinding. Make sure in any case to grind back to the limit line which is marked on the press-out plate by means of a small groove. It makes possible to lift off the individual segments in an even and parallel way.
Step 7: Before renserting the not-sawed tooth , the pin base plate has to be rensed with the cleaner spray MS clean and warm water. The MS clean is used to remove all insulating arreas.
Step 8: Finally, the tooth either by machine with the optional or mesns of the hand tool by using a diamond disc. Make sure that the segments are not bigger than 3 dies even because of the expansion.
Step 9: Afterwards clean the plaster dust carefully from all plaster segments(either by a brush or a steam jet cleaner) and put the segments back on the cleaned base plate.














a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a