915 Generation 1MHZ-1000MHz SWR Bridge Reflection RF Bridge Standing Wave Directional Bridge for Antenna RF Network Measurement(A)

The bridge is a sensor measuring the reflection coefficient for the RF network measurement, the output reflected signal has the amplitude and also the phase information, having a frequency width, high directivity characteristic. The bridge can be combined with the simple application of RF spectrum analyzer or scanner with the trace source, we can measure the return loss and reflection of the entire frequency band of the device;
If combined with vector voltmeter or vector voltage measuring device can accurately measure the applied signal source vector impedance circuit, complete RF matching circuit testing and debugging. Widely used measure debugging, RF circuits and radio, television and communication equipment such as antenna measurements and debugging.
The following is an introduction to the general use of the reflection bridge: Reflective bridge directivity self-calibration: Connect the reflection electric bridge to the output of the tracking signal source of the spectrum analyzer, the frequency range of the spectrum analyzer is set to 1~1000MHz, the level is 100MHz per grid, and the output amplitude of the tracking signal source is 0dBm (others are also possible, the following are all measured by 0dBm output)
The DUT end of the reflection bridge (the end of the device under test) is open. (Nothing is connected, the frequency is low, and the requirements are not high; the frequency is high, the requirements are high, the opener must be connected
Because there is a test end face (position reference), the capacitance of the outer conductor when the inner core is open, etc., can not be N Block is simply open circuit), the 1GHz signal is not high, we can simply open block N. Note down the spectrum analyzer amplitude.

Specifications:
Model: AYT-3; AYT-1
Frequency range: 1MHz ~ 500MHz; 1MHz ~ 1000MHz;
Characteristic Impedance: 50Ω;
Directional: ≥36dB;≥35dB;
Maximum input power: ≤0.2W;
Insertion loss: 6.5dB ± 0.5dB (from the "input" to "measure");
Connector Type: "input" , "output "," Measure " are N Female;
Size: 85 x 45 x 26 (L x W x H) mm(500MHz; )
95x65x32(LxWxH)mm (1000MHz; )
Specification: 1MHz - 500MHz
Color: As Shown
Material: metal+plastic

Package Contents:
1 x SWR Bridge

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.