433 Mhz Universal Gate Remote Control Switch DC 12V 10A Relay Receiver Mini Module Remote Control for Gate LED Garage Door

Input Voltage: 12 V, RF working mode: Superheterodyne

? Receiver sensitivity: > 97 dbm

? Transmitting distance:> 100 m ( open space)

? Decoding mode: MCU software decoding

? Remote storage: 20

? Support remote type: EV1527 learning code

? Working mode: Momentary, toggle, latching time delay (5s ,10s ,15s )

? Output terminal: NO , NC , COM

? Remote control battery: 2 x 3 V CR2016 button batteries

Note: Maximum input power is 250 V

Remote programming

Working mode:

1. Inching mode: press the remote control?the?relay?will connect, and then?release?the remote controlto disconnect the relay;

2. Self-locking mode: press the remote control?the?relay?will connect, and then press the remote control?again?to disconnect the relay;

3. Interlock mode: press the remote control key A to?connect?the relay, and press the remote control key B to disconnect?relay.

4. Delay mode: press the remote control?the?relay?will connect, release the remote control and start timing. After 5S, 10S?and 15S?(3 gears), the relay will be automatically closed.

Learning Methods:

1. Inching learning method:

Press the code?pairing?button on the control panel once, and the LED indicator will flash once. After the LED indicatorlit, press the button?you need to pairing on?the remote control,?the LED indicator on the control panel will flash for 3 times?which means the pairing succeed.

2. Self-locking learning method:

Press the code?pairing?button on the control panel?twice, and the LED indicator will flash?twice. After the LED indicatorlit, press the button?you need to pairing on?the remote control,?the LED indicator on the control panel will flash for 3 times?which means the pairing succeed.

3. Mutual lock learning method:

Press the code?pairing?button on the control panel?three times, and the LED indicator will flash?three times. After the LED indicatorlit, press the button?you need to pairing on?the remote control,?the LED indicator on the control panel will flash for 3 times?which means the pairing succeed.

4.?5S?delay learning method:

Press the code?pairing?button on the control panel four?times, and the LED indicator will flash?four times. After the LED indicatorlit, press the button?you need to pairing on?the remote control,?the LED indicator on the control panel will flash for 3 times?which means the pairing succeed.

5. 10S?delay learning method:

Press the code?pairing?button on the control panel five times, and the LED indicator will flash?five times. After the LED indicatorlit, press the button?you need to pairing on?the remote control,?the LED indicator on the control panel will flash for 3 times?which means the pairing succeed.

6. 15S?delay learning method:

Press the code?pairing?button on the control panel?six times, and the LED indicator will flash?six times. After the LED indicatorlit, press the button?you need to pairing on?the remote control,?the LED indicator on the control panel will flash for 3 times?which means the pairing succeed.

-Clearing the code :

Push the learning button on the receiver 8 times , the codes will be reset.

After clearing the code, remotes will be need to be recalibrated

Package including

1*Receiver module

1*Remote Control (with battery)

">