2001B.1 Bombardier Commander , Style:5-pin 2001B.1 5-pin

2001B.1 Bombardier Commander , Style:5-pin

1. Weight: 350g
2. Category: three-phase full-wave rectifier
3. Output voltage: 14.5+/-0.5V
4. Size: 12x9.5x6cm
Installation precautions:
1. The rectifier should be installed in a location with good ventilation and good heat dissipation. High temperature will be generated when the rectifier is working, and poor heat dissipation will damage the rectifier
2. The installation steps of the rectifier are to connect the AC input line, the positive and negative output are not connected, start the locomotive, measure the positive and negative output voltage, and when the voltage range is reasonable, plug in the positive and negative wires, and then test the positive and negative of the battery or rectifier If the voltage range is unreasonable, stop using it and give feedback. The entire installation process should be recorded and saved.
3. Note that the rectifier should be closely attached to the frame when installing it, which is good for heat conduction. You can also add thermally conductive glue between the rectifier and the frame
4. Do not press other wires between the rectifier and the frame
5. There should be a fuse protection device between the positive outlet of the rectifier and the battery to prevent the rectifier from being damaged and the voltage is too high and other electrical components are burned out
Applicable models:
for Mosfet Application：4012941 31600-HP0-A01 21066-0022 21066-0008 1D7-81960-00-00 27D-81960-00-00 5JW-81960-00-00 710000870 710001103 710001191 278002021 T1300470 540.4.030.1A 12317718422 1D7-81960-01-00 515177325 710000261
for Mosfet Voltage Regulator Rectifier Kawasaki Ninja 2005-2011 ZX 10 R / ZX 14 R
for Can-am Comman r 1000 2011-2014
for Can-am Comman r 1000 4x4 2012
for Can-am Comman r 1000 4x4 EFI 2013
for Can-am Comman r 1000 4x4 EFI CVT 2014
for Can-am Comman r 1000 4x4 EFI CVT DPS 2014
for Can-am Comman r 1000 4x4 EFI CVT Limited Edition 2014
for Can-am Comman r 1